Cargando…

Sensing Method Using Multiple Quantities for Diagnostic of Insulators in Different Ambient Conditions

Insulators are one of the many components responsible for the reliability of electricity supply as part of transmission and distribution lines. Failure of the insulator can cause considerable economic problems that are much greater than the insulator cost. When the failure occurs on the transmission...

Descripción completa

Detalles Bibliográficos
Autores principales:	Dolník, Bystrík, Šárpataky, Ľuboš, Kolcunová, Iraida, Havran, Peter
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2022
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8963003/ https://www.ncbi.nlm.nih.gov/pubmed/35214277 http://dx.doi.org/10.3390/s22041376

Ejemplares similares

Sensing Method Using Dielectric Loss Factor to Evaluate Surface Conditions on Polluted Porcelain Insulator
por: Šárpataky, Ľuboš, et al.
Publicado: (2022)

Analysis of the Impact of Selected Physical Environmental Factors on the Health of Employees: Creating a Classification Model Using a Decision Tree
por: Andrejiová, Miriam, et al.
Publicado: (2019)

Direct writing of graphene patterns on insulating substrates under ambient conditions
por: Xiong, Wei, et al.
Publicado: (2014)

The validity of Actiwatch2 and SenseWear armband compared against polysomnography at different ambient temperature conditions
por: Shin, Mirim, et al.
Publicado: (2015)

Diagnosis of Insulation Condition of MV Switchgears by Application of Different Partial Discharge Measuring Methods and Sensors
por: Álvarez Gómez, Fernando, et al.
Publicado: (2018)

Thermophysiological and Perceptual Responses of Amateur Healthcare Workers: Impacts of Ambient Condition, Inner-Garment Insulation and Personal Cooling Strategy
por: Zhao, Yingying, et al.
Publicado: (2022)

Influence of Pre-Analytic Conditions on Quantity of Lymphocytes
por: Proschmann, Undine, et al.
Publicado: (2023)

Optically detecting the edge-state of a three-dimensional topological insulator under ambient conditions by ultrafast infrared photoluminescence spectroscopy
por: Maezawa, Shun-ya, et al.
Publicado: (2015)

Optimal models and methods with fuzzy quantities
por: Cao, Bing-Yuan, et al.
Publicado: (2010)

New Insulating Fluids and Diagnostic Techniques for Paper-Oil Insulated Equipment(1)
por: Lyutikova, M. N., et al.
Publicado: (2021)

Thermodynamics of quantum systems with multiple conserved quantities
por: Guryanova, Yelena, et al.
Publicado: (2016)

Analytical determination of theoretic quantities for multiple potential
por: Onate, C. A., et al.
Publicado: (2020)

Quantum nanodiamonds for sensing of biological quantities: Angle, temperature, and thermal conductivity
por: Sotoma, Shingo, et al.
Publicado: (2022)

Difference in quantity discrimination in dogs and wolves
por: Range, Friederike, et al.
Publicado: (2014)

Thermal Insulation and Mechanical Properties of Polylactic Acid (PLA) at Different Processing Conditions
por: Barkhad, Mohamed Saeed, et al.
Publicado: (2020)

New Perspectives on the Biogenesis of Viral Inclusion Bodies in Negative-Sense RNA Virus Infections
por: Dolnik, Olga, et al.
Publicado: (2021)

Dielectric Measurement Based Deducted Quantities to Track Repetitive, Short-Term Thermal Aging of Polyvinyl Chloride (PVC) Cable Insulation
por: Csányi, Gergely Márk, et al.
Publicado: (2020)

Canine sense of quantity: evidence for numerical ratio-dependent activation in parietotemporal cortex
por: Aulet, Lauren S., et al.
Publicado: (2019)

Ultra-Low-Power Digital Filtering for Insulated EMG Sensing
por: Roland, Theresa, et al.
Publicado: (2019)

Sound-Absorption Coefficient of Bark-Based Insulation Panels
por: Tudor, Eugenia Mariana, et al.
Publicado: (2020)

Hydrogen Sensing Performance of ZnO Schottky Diodes in Humid Ambient Conditions with PMMA Membrane Layer
por: Jang, Soohwan, et al.
Publicado: (2020)

Dielectric Fluids for Power Transformers with Special Emphasis on Biodegradable Nanofluids
por: Šárpataky, Miloš, et al.
Publicado: (2021)

Which Physical Quantity Deserves the Name “Quantity of Heat”?
por: Herrmann, Friedrich, et al.
Publicado: (2021)

APPARATUS FOR FREEZING AND DRYING VIRUS IN LARGE QUANTITIES UNDER UNIFORM CONDITIONS
por: Bauer, Johannes H., et al.
Publicado: (1940)

Multiple Physical Quantities Janus Metastructure Sensor Based on PSHE
por: Sui, Junyang, et al.
Publicado: (2023)

Influence of exercise on quantity and deformability of immune cells in multiple sclerosis
por: Proschmann, Undine, et al.
Publicado: (2023)

On the Best Method of Detecting Small Quantities of Albumen in the Urine
por: Clark, Andrew
Publicado: (1866)

Electrically Insulated Sensing of Respiratory Rate and Heartbeat Using Optical Fibers
por: Suaste-Gómez, Ernesto, et al.
Publicado: (2014)

Enhanced Ambient Sensing Environment—A New Method for Calibrating Low-Cost Gas Sensors
por: Russell, Hugo Savill, et al.
Publicado: (2022)

A Multiple Shape Memory Hydrogel Induced by Reversible Physical Interactions at Ambient Condition
por: Xiao, He, et al.
Publicado: (2017)

Research and Analysis of Insulating Gas in Unified Test Conditions
por: You, Tianpeng, et al.
Publicado: (2022)

Hypocrystalline ceramic aerogels for thermal insulation at extreme conditions
por: Guo, Jingran, et al.
Publicado: (2022)

Combining correlated measurements of several different physical quantities
por: Valassi, Andrea
Publicado: (2003)

Quality and Quantity.
Publicado: (1975)

Quantity assurance
por: LeBrasseur, Nicole
Publicado: (2002)

Astrophysical quantities
por: Allen, Clabon Walter
Publicado: (1973)

Astrophysical quantities
por: Allen, Clabon Walter
Publicado: (1963)

Taxonomy of quantities
por: Fuentes-Arderiu, Xavier
Publicado: (2012)

Quantity of Food
Publicado: (1896)

Voronoi Decomposition of Cardiovascular Dependency Structures in Different Ambient Conditions: An Entropy Study
por: Bajic, Dragana, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_50gsv76meg7l0t157k26r6ui6b