Use of a larger surface area tip on bipolar radiofrequency wands in hip arthroscopy is associated with significantly lower traction and total surgery times

Clinical outcomes in arthroscopic hip preservation surgery have improved over the past two decades due to many factors, including advancements in technique and instrumentation. Complications following hip arthroscopy are associated with increased traction and overall surgical times. The purpose of this study was to compare traction and surgical times during hip arthroscopy using two different radiofrequency ablation wands produced by the same manufacturer. The authors hypothesized that the wand with a larger surface area would result in significantly less traction and surgical times. This study was a retrospective comparative investigation on patients who underwent arthroscopic surgery of the central, peripheral, peritrochanteric and/or deep gluteal space compartments of the hip. Both wands are 50-degree-angled probes, but the tip and shaft diameters are 3 and 3.75 mm for Wand A (Ambient Super MultiVac 50; tip surface area 7.1 mm(2)) compared to 4.7 and 4.7 mm for Wand B (Ambient HipVac 50; tip surface area 17.3 mm(2)), respectively. There was no difference (P = 0.16) in mean age of Wand A patients (30 females, 20 males; 35.2 years) versus Wand B patients (31 females, 19 males; 32.7 years). Traction time was significantly less in the Wand B group (41 ± 6 versus 51 ± 18 min; P < 0.001), as was surgical time (102 ± 13 versus 118 ± 17 min; P < 0.001). There were no significant differences in the number of labral anchors used or Current Procedural Terminology codes performed between groups. In conclusion, it was observed that the use of a larger surface area wand was associated with significantly less traction and surgical times during hip arthroscopy.