Three-Dimensional (3D) Stereolithographic Tooth Replicas Accuracy Evaluation: In Vitro Pilot Study for Dental Auto-Transplant Surgical Procedures

After immediate tooth extraction or after alveolar socket healing, tooth transplants are increasingly used for functional restoration of edentulous maxillary areas. Recent studies have shown the periodontal ligament (PDL) viability and the tooth housing time in the adapted neo-alveolus as key factors for transplantation success. During surgical time, 3D stereolithographic replicas are used for fitting test procedures. In this paper, the accuracy of 3D dental replicas, compared with the corresponding natural teeth, is assessed in surgical transplantation. Lamb skulls were selected and submitted to Cone Beam Computer Tomography (CBCT). Scanning information, converted into Standard Digital Imaging and Communications in Medicine (DICOM) and Standard Triangulation Language (STL), was sent to the Volux X-ray Centre for 3D replica printing. After the tooth extractions, all lambs’ incisors were measured with a digital caliber and compared with the 3D replicas. Volume and dimensional error values were evaluated. All replicas showed macroscopically smaller volume (45.54%). Root replicas showed higher variations compared with the crown areas, with several unreplicated apical root areas. The cement–enamel junction tooth area was replicated quite faithfully, and the base area relative error showed 9.8% mean value. Even further studies with a larger number of replicas are needed. Data obtained confirmed high volumes of macroscopic discrepancies with several unreproduced apical root sites. The achieved accuracy (90.2%) confirmed that the 3D replicas cannot be used to reduce the surgical time during transplantation predictable procedures.