Hydrogen production rates of aluminum reacting with varying densities of supercritical water

Aluminum particles, spanning in size from 10 μm to 3 mm, were reacted with varying densities of water at 655 K. The density of the water is varied from 50 g L(−1) to 450 g L(−1) in order to understand the effect of density on both reaction rates and yields. Low-density supercritical water is associated with properties that make it an efficient oxidizer: low viscosity, high diffusion, and low relative permittivity. Despite this, it was found that the high-density (450 g L(−1)) supercritical water was the most efficient oxidizer both in terms of reaction rate and hydrogen yield. The 10 μm powder had a peak reaction rate of approximately 675 cm(H(2))(3) min(−1) g(Al)(−1) in the high-density water, and a peak reaction rate below 250 cm(H(2))(3) min(−1) g(Al)(−1) in the low- and vapour-density water. A decline in peak reaction rate with decreasing water density was also observed for the 120 μm powder and the 3 mm slugs. These findings imply that the increased collision frequency, a property of the high-density water, outpaces reduction in the reaction enhancing properties associated with low-density supercritical water. Hydrogen yield was minimally affected by decreasing the oxidizer density from 450 g L(−1) to 200 g L(−1), but did drop off significantly in the vapour-density (50 g L(−1)) water.