Cargando…

Experimental investigation of heat transfer for diesel spray impingement on a high temperature wall

In this paper, the heat transfer characteristics of spray-wall impingement on a high temperature wall were studied by using a transient thermocouple and a one-dimensional finite-difference conduction model to obtain variations of wall temperature and heat flux. Results showed that increasing the inj...

Descripción completa

Detalles Bibliográficos
Autores principales:	Guo, Zhenyao, Zhang, Weizheng, Jin, Shuang, Shi, Zhicheng, Yuan, Yanpeng
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Nature Publishing Group UK 2022
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9042839/ https://www.ncbi.nlm.nih.gov/pubmed/35474121 http://dx.doi.org/10.1038/s41598-022-10959-6

Ejemplares similares

Nanofluid impingement jet heat transfer
por: Zeitoun, Obida, et al.
Publicado: (2012)

Investigation of Needle Motion Profile Effect on Diesel Spray in Near-Nozzle Field
por: Gao, Ya, et al.
Publicado: (2022)

Experimental and Numerical Investigation of Flow Structure and Heat Transfer Behavior of Multiple Jet Impingement Using MgO-Water Nanofluids
por: Tang, Tsz Loong, et al.
Publicado: (2023)

Heat transfer behavior caused by temperature difference in reciprocating sliding contact
por: Liu, Yuwei, et al.
Publicado: (2020)

Investigation of the transient heat transfer to a supersonic air jet impinging on a high-temperature plate based on a discrimination-experiment method
por: Gao, Ming-Xin, et al.
Publicado: (2022)

The surfactants effect on the heat transfer enhancement and stability of nanofluid at constant wall temperature
por: Askar, Ali Habeeb, et al.
Publicado: (2020)

Thermally Developing Flow and Heat Transfer in Elliptical Minichannels with Constant Wall Temperature
por: Su, Liangbin, et al.
Publicado: (2019)

Experimental investigation into the oxidation reactivity and nanostructure of particulate matter from diesel engine fuelled with diesel/polyoxymethylene dimethyl ethers blends
por: Yang, Hao, et al.
Publicado: (2016)

Experimental Investigation of the Flow and Heat Transfer Characteristics in Microchannel Heat Exchangers with Reentrant Cavities
por: Huang, Binghuan, et al.
Publicado: (2020)

Heat transfer at low temperatures
por: Frost, Walter
Publicado: (1975)

Analysis of diesel engine injector nozzle spray characteristics fueled with residual fuel oil
por: Achebe, C.H., et al.
Publicado: (2020)

Simulation data for similarity of spray combustion processes in marine low-speed diesel engines
por: Zhou, Xinyi, et al.
Publicado: (2019)

Experimental investigation of the hydraulic and heat-transfer properties of artificially fractured granite
por: Luo, Jin, et al.
Publicado: (2017)

Impact of the TiO(2) Nanosolution Concentration on Heat Transfer Enhancement of the Twin Impingement Jet of a Heated Aluminum Plate
por: Faris Abdullah, Mahir, et al.
Publicado: (2019)

A Review on Experimental and Numerical Investigations of Jet Impingement Cooling Performance with Nanofluids
por: Wai, Ooi Jen, et al.
Publicado: (2022)

Experimental Investigation of the Emission and Performance Characteristics of a DI Diesel Engine Fueled with the Vachellia nilotica Seed Oil Methyl Ester and Diesel Blends
por: Sriharikota, Chandra Sekhar, et al.
Publicado: (2021)

Experimental and empirical investigation of a CI engine fuelled with blends of diesel and roselle biodiesel
por: Verma, Tikendra Nath, et al.
Publicado: (2021)

Spray and Combustion Characteristics of CTL–Diesel Fuel Blends in a Constant-Volume Combustion Chamber
por: Liu, Songtao, et al.
Publicado: (2023)

Experimental Investigation of an Intensified Heat Transfer Adsorption Bed (IHTAB) Reactor Prototype
por: Grabowska, Karolina, et al.
Publicado: (2021)

Estimation of Surface Heat Flux and Surface Temperature during Inverse Heat Conduction under Varying Spray Parameters and Sample Initial Temperature
por: Aamir, Muhammad, et al.
Publicado: (2014)

Elevated Temperature Tensile Creep Behavior of Aluminum Borate Whisker-Reinforced Aluminum Alloy Composites (ABOw/Al–12Si)
por: Ji, Yameng, et al.
Publicado: (2021)

Experimental data of heat transfer nanofluids for trigeneration systems: viscosity at below-ambient temperatures
por: Nobre, Guilherme Cunha Maia, et al.
Publicado: (2023)

The ceramic SPRAYMAT: a flame-sprayed ceramic-metal heating element for the heating of metallic walls of vacuum chambers for accelerated outgassing
por: Achermann, A H
Publicado: (1962)

Heat Transfer and Flow Structures of Laminar Confined Slot Impingement Jet with Power-Law Non-Newtonian Fluid
por: Qiang, Yan, et al.
Publicado: (2018)

A High-Temperature MEMS Surface Fence for Wall-Shear-Stress Measurement in Scramjet Flow
por: Ma, Chengyu, et al.
Publicado: (2017)

Microencapsulation of β-Carotene by Spray Drying: Effect of Wall Material Concentration and Drying Inlet Temperature
por: Corrêa-Filho, Luiz C., et al.
Publicado: (2019)

Spray Drying Encapsulation of Pediococcus acidilactici at Different Inlet Air Temperatures and Wall Material Ratios
por: Tirta, Gabriella Devina, et al.
Publicado: (2022)

Experimental investigation of flow boiling heat transfer enhancement under ultrasound fields in a minichannel heat sink
por: Yu, Fan, et al.
Publicado: (2020)

Storage and Temperature Stability of Emulsified Biodiesel–Diesel Blends
por: Maji, Nitai C., et al.
Publicado: (2022)

Experimental Investigation of a Multicylinder Unmodified Diesel Engine Performance, Emission, and Heat Loss Characteristics Using Different Biodiesel Blends: Rollout of B10 in Malaysia
por: Abedin, M. J., et al.
Publicado: (2014)

Metallization of Porous Polyethylene Using a Wire-Arc Spray Process for Heat Transfer Applications
por: Devaraj, S., et al.
Publicado: (2021)

Heat Transfer Enhancement in Unsteady MHD Natural Convective Flow of CNTs Oldroyd-B Nanofluid under Ramped Wall Velocity and Ramped Wall Temperature
por: Anwar, Talha, et al.
Publicado: (2020)

Heat Transfer and Cooling Techniques at Low Temperature
por: Baudouy, B
Publicado: (2015)

Experimental and numerical investigations on spray characteristics of fatty acid methyl esters
por: Lanjekar, R. D., et al.
Publicado: (2018)

Computational and Experimental Investigation of Biofilm Disruption Dynamics Induced by High-Velocity Gas Jet Impingement
por: Prades, Lledó, et al.
Publicado: (2020)

Measurements of the temperatures on a heated niobium-wall in subcooled helium
por: Wittenborn, W
Publicado: (1981)

Esophageal Heat Transfer for Patient Temperature Control and Targeted Temperature Management
por: Naiman, Melissa I., et al.
Publicado: (2017)

Experimental and Numerical Investigation into the Heat- and Mass-Transfer Processes of n-Butane Adsorption on Activated Carbon
por: Zhao, Fei, et al.
Publicado: (2021)

Experimental investigations of He II heat transfer through a short section of LHC inner triplet quadrupole heat exchanger
por: Darve, C, et al.
Publicado: (2001)

Flow organization and heat transfer in turbulent wall sheared thermal convection
por: Blass, Alexander, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_rjji9jfet0iiapq79nm871loru