Cargando…

Enhanced efficiency of Cu(2)ZnSn(S,Se)(4) solar cells via anti-reflectance properties and surface passivation by atomic layer deposited aluminum oxide

Reducing interface recombination losses is one of the major challenges in developing Cu(2)ZnSn(S,Se)(4) (CZTSSe) solar cells. Here, we propose a CZTSSe solar cell with an atomic layer deposited Al(2)O(3) thin film for surface passivation. The influence of passivation layer thickness on the power con...

Descripción completa

Detalles Bibliográficos
Autores principales:	Zhang, Bingye, Han, Lu, Ying, Shitian, Li, Yongfeng, Yao, Bin
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	The Royal Society of Chemistry 2018
Materias:	Chemistry
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9080692/ https://www.ncbi.nlm.nih.gov/pubmed/35539659 http://dx.doi.org/10.1039/c8ra03437k

Ejemplares similares

Inkjet‐Printed Cu(2)ZnSn(S, Se)(4) Solar Cells
por: Lin, Xianzhong, et al.
Publicado: (2015)

Solution-Processed Cu(2)ZnSn(S,Se)(4) Thin-Film Solar Cells Using Elemental Cu, Zn, Sn, S, and Se Powders as Source
por: Guo, Jing, et al.
Publicado: (2015)

Exploring the Effect of Selenidation Time on the Ni-Doped Cu(2)ZnSn(S,Se)(4) Solar Cell
por: Zeng, Fancong, et al.
Publicado: (2022)

Performance Enhancement in Powder-Fabricated Cu(2)(ZnSn)Se(4) Solar Cell by Roll Compression
por: Park, Jaehyun, et al.
Publicado: (2023)

Flexible Cu(2)ZnSn(S,Se)(4) solar cells with over 10% efficiency and methods of enlarging the cell area
por: Yang, Kee-Jeong, et al.
Publicado: (2019)

Impact of Na Doping on the Carrier Transport Path in Polycrystalline Flexible Cu(2)ZnSn(S,Se)(4) Solar Cells
por: Jeong, Woo‐Lim, et al.
Publicado: (2020)

Efficient (Cu(1−x)Ag(x))(2)ZnSn(S,Se)(4) solar cells on flexible Mo foils
por: Yu, Xue, et al.
Publicado: (2018)

Insight into the Effect of Selenization Temperature for Highly Efficient Ni-Doped Cu(2)ZnSn(S,Se)(4) Solar Cells
por: Zeng, Fancong, et al.
Publicado: (2022)

Influence of alkali metals (Na, Li, Rb) on the performance of electrostatic spray-assisted vapor deposited Cu(2)ZnSn(S,Se)(4) solar cells
por: Altamura, Giovanni, et al.
Publicado: (2016)

Cu(2)ZnSn(S,Se)(4) thin-films prepared from selenized nanocrystals ink
por: Aruna-Devi, R., et al.
Publicado: (2019)

Sulfurization induced surface constitution and its correlation to the performance of solution-processed Cu(2)ZnSn(S,Se)(4) solar cells
por: Zhong, Jie, et al.
Publicado: (2014)

Reducing series resistance in Cu(2)ZnSn(S,Se)(4) nanoparticle ink solar cells on flexible molybdenum foil substrates
por: Xu, Xinya, et al.
Publicado: (2018)

Analytical Modeling and Optimization of Cu(2)ZnSn(S,Se)(4) Solar Cells with the Use of Quantum Wells under the Radiative Limit
por: Rodriguez-Osorio, Karina G., et al.
Publicado: (2023)

Optimization of the Selenization Temperature on the Mn-Substituted Cu(2)ZnSn(S,Se)(4) Thin Films and Its Impact on the Performance of Solar Cells
por: Wang, Zhanwu, et al.
Publicado: (2022)

Substitution of Ag for Cu in Cu(2)ZnSn(S,Se)(4): Toward Wide Band Gap Absorbers with Low Antisite Defects for Thin Film Solar Cells
por: Wu, Yanjie, et al.
Publicado: (2020)

Mapping Shunting Paths at the Surface of Cu(2)ZnSn(S,Se)(4) Films via Energy-Filtered Photoemission Microscopy
por: Tiwari, Devendra, et al.
Publicado: (2018)

Enhancing the Performance of Aqueous Solution-Processed Cu(2)ZnSn(S,Se)(4) Photovoltaic Materials by Mn(2+) Substitution
por: He, Wenjie, et al.
Publicado: (2020)

Band-gap-graded Cu(2)ZnSn(S(1-x),Se(x))(4) Solar Cells Fabricated by an Ethanol-based, Particulate Precursor Ink Route
por: Woo, Kyoohee, et al.
Publicado: (2013)

Aqueous-Solution-Processed Cu(2)ZnSn(S,Se)(4) Thin-Film Solar Cells via an Improved Successive Ion-Layer-Adsorption–Reaction Sequence
por: Suryawanshi, Mahesh P., et al.
Publicado: (2017)

A Study on the Effects of Selenization Temperature on the Properties of Na-Doped Cu(2)ZnSn(S,Se)(4) Thin Film and Its Correlation with the Performance of Solar Cells
por: Wang, Zhanwu, et al.
Publicado: (2021)

Improving Ultraviolet Responses in Cu(2)ZnSn(S,Se)(4) Thin-Film Solar Cells Using Quantum Dot-Based Luminescent Down-Shifting Layer
por: Jeong, Woo-Lim, et al.
Publicado: (2021)

Doping of Sb into Cu(2)ZnSn(S,Se)(4) absorber layer via Se&Sb(2)Se(3) co-selenization strategy for enhancing open-circuit voltage of kesterite solar cells
por: Zhao, Benhui, et al.
Publicado: (2022)

A Route to Phase Controllable Cu(2)ZnSn(S(1−x)Se(x))(4) Nanocrystals with Tunable Energy Bands
por: Ji, Shulin, et al.
Publicado: (2013)

DMF‐Based Large‐Grain Spanning Cu(2)ZnSn(S (x) ,Se(1‐) (x) )(4) Device with a PCE of 11.76%
por: Cui, Yubo, et al.
Publicado: (2022)

Magnetotransport and conductivity mechanisms in Cu(2)ZnSn(x)Ge(1−x)S(4) single crystals
por: Lähderanta, Erkki, et al.
Publicado: (2018)

Nanoscale observation of surface potential and carrier transport in Cu(2)ZnSn(S,Se)(4) thin films grown by sputtering-based two-step process
por: Kim, Gee Yeong, et al.
Publicado: (2014)

Spectroscopy and Theoretical Modeling of Phonon Vibration Modes and Band Gap Energy of Cu(2)ZnSn(S(x)Se(1–x))(4) Bulk Crystals and Thin Films
por: Babichuk, Ivan S., et al.
Publicado: (2021)

Schottky Contacts to ZnO-Nanocoated SnSe Powders by Atomic Layer Deposition
por: Kim, Hogyoung, et al.
Publicado: (2022)

Contrasting the Material Chemistry of Cu(2)ZnSnSe(4) and Cu(2)ZnSnS((4–) (x) ())Se(x)
por: Aguiar, Jeffery A., et al.
Publicado: (2016)

Growth of Epitaxial ZnSn(x)Ge(1−x)N(2) Alloys by MBE
por: Shing, Amanda M., et al.
Publicado: (2017)

Enhanced omnidirectional and weatherability of Cu(2)ZnSnSe(4) solar cells with ZnO functional nanorod arrays
por: Lai, Fang-I, et al.
Publicado: (2017)

Atomic Layer Deposition of Ultrathin ZnO Films for Hybrid Window Layers for Cu(In(x),Ga(1−x))Se(2) Solar Cells
por: Lee, Jaebaek, et al.
Publicado: (2021)

CZTSe solar cells prepared by electrodeposition of Cu/Sn/Zn stack layer followed by selenization at low Se pressure
por: Yao, Liyong, et al.
Publicado: (2014)

Effect of Sn Content in a CuSnZn Metal Precursor on Formation of MoSe(2) Film during Selenization in Se+SnSe Vapor
por: Yao, Liyong, et al.
Publicado: (2016)

Atomic Sulfur Passivation Improves the Photoelectrochemical Performance of ZnSe Nanorods
por: Huang, Fei, et al.
Publicado: (2020)

Enhanced Si Passivation and PERC Solar Cell Efficiency by Atomic Layer Deposited Aluminum Oxide with Two-step Post Annealing
por: Hsu, Chia-Hsun, et al.
Publicado: (2019)

Mechanochemical Synthesis of Sustainable Ternary and Quaternary Nanostructured Cu(2)SnS(3), Cu(2)ZnSnS(4), and Cu(2)ZnSnSe(4) Chalcogenides for Thermoelectric Applications
por: Nautiyal, Himanshu, et al.
Publicado: (2023)

The Effect of Surface Hydroxyls on the Humidity-Sensitive Properties of LiCl-Doped ZnSn(OH)(6) Sphere-Based Sensors
por: Li, Zhenjiang, et al.
Publicado: (2022)

Influence of the Al-Doped ZnO Sputter-Deposition Temperature on Cu(In,Ga)Se(2) Solar Cell Performance
por: Park, Hyeonwook, et al.
Publicado: (2022)

Direct evidence for grain boundary passivation in Cu(In,Ga)Se(2) solar cells through alkali-fluoride post-deposition treatments
por: Nicoara, Nicoleta, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_msksbdsahq3v997i0vr5b6hprt