Cargando…

Deep Cryogenic Treatment Characteristics of a Deformation-Processed Cu-Ni-Co-Si Alloy

This paper investigated the influence of deep cryogenic treatments (DCT) on the tensile strength, elongation to fracture and conductivity of a deformation-processed Cu-Ni-Co-Si alloy. The tensile properties were measured using a mechanical testing machine. The conductivity was evaluated using a low-...

Descripción completa

Detalles Bibliográficos
Autores principales:	Liu, Keming, Sheng, Xiaochun, Li, Xiaolong, Li, Mulin, Shen, Zhi, Fu, Kai, Zhou, Haitao, Atrens, Andrej
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2022
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9100281/ https://www.ncbi.nlm.nih.gov/pubmed/35591386 http://dx.doi.org/10.3390/ma15093051

Ejemplares similares

Influence of Si, Cu, B, and Trace Alloying Elements on the Conductivity of the Al-Si-Cu Alloy
por: Yang, Zhao, et al.
Publicado: (2022)

Hot Deformation Behavior and Microstructure Evolution of Cu–Ni–Co–Si Alloys
por: Liu, Feng, et al.
Publicado: (2020)

Microstructure and Strengthening Model of Cu–Fe In-Situ Composites
por: Liu, Keming, et al.
Publicado: (2020)

Precipitation Strengthening of Cu–Ni–Si Alloy
por: Krupińska, Beata, et al.
Publicado: (2020)

Tensile and Fracture Toughness Tests of CuNiSi at Room and Cryogenic Temperatures
por: Ageladarakis, P A
Publicado: (1999)

Enhanced Strength and Plasticity of CoCrNiAl(0.1)Si(0.1) Medium Entropy Alloy via Deformation Twinning and Microband at Cryogenic Temperature
por: Gu, Xiao-Hua, et al.
Publicado: (2021)

Effect of Ni/Si Mass Ratio and Thermomechanical Treatment on the Microstructure and Properties of Cu-Ni-Si Alloys
por: Li, Jiang, et al.
Publicado: (2019)

Effect and Mechanism of Solidified Microstructure on Deformation Behavior, Mechanical Properties, and Residual Stress of Cu-Ni-Si Alloy
por: Liao, Wanneng, et al.
Publicado: (2022)

The Influence of Ag on the Microstructure and Properties of Cu-Ni-Si Alloys
por: Krupińska, Beata, et al.
Publicado: (2020)

Ageing Behaviour of Al–Mg–Si Alloys After Cryogenic and Room Temperature Deformation
por: Gruber, Belinda, et al.
Publicado: (2020)

Influence of the Ni/Co Mass Ratio on the Microstructure and Properties of Quaternary Cu-Ni-Co-Si Alloys
por: Li, Jiang, et al.
Publicado: (2019)

Large Cryogenic Magnetostriction Induced by Hydrostatic Pressure in MnCo(0.92)Ni(0.08)Si Alloy
por: Hao, Xiaowen, et al.
Publicado: (2023)

Effects of Deformation at High, Medium, and Cryogenic Temperatures on the Microstructures and Mechanical Properties of Al-Zn-Mg-Cu Alloys
por: Zhang, Wenxue, et al.
Publicado: (2022)

Effects of Co Addition on the Properties and Microstructure of Cu-Ni-Si-P-Mg Alloys
por: Cheng, Jianyi, et al.
Publicado: (2021)

Investigation of Microstructure and Wear Properties of Precipitates-Strengthened Cu-Ni-Si-Fe Alloy
por: Peng, Chun-Hao, et al.
Publicado: (2023)

Effect of Cu as a Minority Alloying Element on the Corrosion Behaviour of Amorphous and Crystalline Al-Ni-Si Alloy
por: Dyakova, Vanya, et al.
Publicado: (2023)

Microstructure and Wear Resistance of Laser-Clad Ni–Cu–Mo–W–Si Coatings on a Cu–Cr–Zr Alloy
por: Zhao, Xiaojun, et al.
Publicado: (2022)

Aging Response and Precipitation Behavior after 5% Pre-Deformation of an Al-Mg-Si-Cu Alloy
por: Jin, Shuoxun, et al.
Publicado: (2018)

Effects of Co Addition on the Microstructure and Properties of Elastic Cu-Ni-Si-Based Alloys for Electrical Connectors
por: Wang, Zheng, et al.
Publicado: (2021)

Effect of Ni Content on Microstructure and Characterization of Cu-Ni-Sn Alloys
por: Du, Sanming, et al.
Publicado: (2018)

Microstructure Evolution in Cu-Ni-Co-Si-Cr Alloy During Hot Compression by Ce Addition
por: Ban, Yijie, et al.
Publicado: (2020)

Thermal Analysis and Selected Properties of CuNi2Si Alloy Used for Railway Traction
por: Konieczny, Jarosław, et al.
Publicado: (2021)

Biodegradation, Antibacterial Performance, and Cytocompatibility of a Novel ZK30-Cu-Mn Biomedical Alloy Produced by Selective Laser Melting
por: Xie, Bin, et al.
Publicado: (2020)

Crystallization Features of Amorphous Rapidly Quenched High Cu Content TiNiCu Alloys upon Severe Plastic Deformation
por: Glezer, Alexander, et al.
Publicado: (2019)

Anodic Fabrication of Ti-Ni-Si-O Nanostructures on Ti10Ni5Si Alloy
por: Li, Ting, et al.
Publicado: (2019)

Photoelectrochemical Water Splitting Properties of Ti-Ni-Si-O Nanostructures on Ti-Ni-Si Alloy
por: Li, Ting, et al.
Publicado: (2017)

Experimental and Numerical Studies on Hot Compressive Deformation Behavior of a Cu–Ni–Sn–Mn–Zn Alloy
por: Zhang, Yufang, et al.
Publicado: (2023)

Revealing the Effect of Local Connectivity of Rigid Phases during Deformation at High Temperature of Cast AlSi12Cu4Ni(2,3)Mg Alloys
por: Bugelnig, Katrin, et al.
Publicado: (2018)

Fatigue Crack Growth Behaviour of Precipitate-Strengthened CuNi(2)Si Alloy under Different Loading Modes
por: Yang, Bing, et al.
Publicado: (2020)

Improving the Thermal Stability of the Fine-Grained Structure in the Cu-15Ni-8Sn Alloy during Solution Treatment by the Additions of Si and Ti
por: Zhao, Chao, et al.
Publicado: (2023)

Magnetism and magnetoresistance of single Ni–Cu alloy nanowires
por: Costas, Andreea, et al.
Publicado: (2018)

Cryogenic strength improvement by utilizing room-temperature deformation twinning in a partially recrystallized VCrMnFeCoNi high-entropy alloy
por: Jo, Y. H., et al.
Publicado: (2017)

Effects of Solidification Cooling Rate on the Microstructure and Mechanical Properties of a Cast Al-Si-Cu-Mg-Ni Piston Alloy
por: Tian, Lusha, et al.
Publicado: (2018)

Revealing the Effect of Phase Composition and Transformation on the Mechanical Properties of a Cu–6Ni–6Sn–0.6Si Alloy
por: Liang, Zhuanqin, et al.
Publicado: (2021)

Recovery of strain-hardening rate in Ni-Si alloys
por: Yang, C. L., et al.
Publicado: (2015)

Improving the Mechanical Properties of Cu-15Ni-8Sn Alloys by Addition of Titanium
por: Zhao, Chao, et al.
Publicado: (2017)

Effect of Pretreatment and Cryogenic Temperatures on Mechanical Properties and Microstructure of Al-Cu-Li Alloy
por: Wang, Cheng, et al.
Publicado: (2021)

Effects of Machining Velocity on Ultra-Fine Grained Al 7075 Alloy Produced by Cryogenic Temperature Large Strain Extrusion Machining
por: Yin, Xiaolong, et al.
Publicado: (2019)

Research on the Hot Deformation Behavior of the Casting NiTi Alloy
por: Tao, Chengchuang, et al.
Publicado: (2021)

Effect of Si and C additions on the reaction mechanism and mechanical properties of FeCrNiCu high entropy alloy
por: Wu, Hao, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_94d815adoqg02e1mmbnfoacu0f