Cargando…
Comparative Study on Macro-Tribological Properties of PLL-g-PEG and PSPMA Polymer Brushes
An ultra-low friction and high load capacity could be obtained on the surfaces grafted by a polymer brush even at relatively slow friction speeds in aqueous lubrication environments, which has attracted widespread attention to study the lubrication mechanism of polymer brushes; however, it has yet t...
Autores principales: | , , , , |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2022
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9103741/ https://www.ncbi.nlm.nih.gov/pubmed/35567086 http://dx.doi.org/10.3390/polym14091917 |
Sumario: | An ultra-low friction and high load capacity could be obtained on the surfaces grafted by a polymer brush even at relatively slow friction speeds in aqueous lubrication environments, which has attracted widespread attention to study the lubrication mechanism of polymer brushes; however, it has yet to be fully understood. The macroscopic tribological performance of two different polymer brushes, which were prepared by the method of “grafting to” and “grafting from” and named as PLL-g-PEG and PSPMA, respectively, were investigated. The friction results demonstrated that PLL-g-PEG obtained a lower friction coefficient than polymer brush PSPMA, which was ascribed to its unique “self-healing” behavior. The lubrication film was in situ observed and the film thickness induced by the polymer brush was measured using a laboratory set for film thickness measurement apparatus based on interference technology. It was found that PSPMA exhibited excellent lubrication performance not found in PLL-g-PEG, and two film-forming mechanisms highly dependent on velocity were revealed, which may be important to interpret the lubrication mechanism of polymer brushes in aqueous lubricants. |
---|