Investigation of Microstructures and Mechanical Properties of SiC/AA2024 Nanocomposites Processed by Powder Metallurgy and T6 Heat Treatment

SiC/AA2024 nanocomposites with 1 and 5 vol.% SiC nanoparticles have been prepared by a powder metallurgy route involving high-energy ball-milling (HEBM), spark plasma sintering (SPS), and hot extrusion. The microstructures and mechanical properties of the nanocomposite samples before and after T6 heat treatment were investigated. The samples exhibited a bimodal microstructure with SiC nanoparticles being dispersed in it. With increasing the SiC nanoparticle content from 1 to 5 vol.%, the yield strength (YS) and ultimate tensile strength (UTS) increased and the elongation to fracture (El) slightly decreased. After T6 heat treatment, a simultaneous improvement of the strength and ductility was observed, with the YS, UTS, and El increasing from 413 MPa, 501 MPa, and 5.4% to 496 MPa, 572 MPa, and 6.7%, respectively, in the 1 vol.%SiC/AA2024 nanocomposite sample. Analysis of the deformation behavior shows that this improvement is likely caused by the increased density of geometrically necessary dislocations (GNDs) resulting from the bimodal microstructure. The dispersed intragranular Sʹ precipitates generated by the T6 heat treatment also make a contribution to the increase of strength and ductility by accumulating dislocations. It is feasible to realize simultaneous improvement of strength and ductility in the SiC/AA2024 nanocomposites via powder metallurgy and subsequent heat treatment.