Numerical Investigation of the Influence of Ultimate-Strength Heterogeneity on Crack Propagation and Fracture Toughness in Welded Joints

The mechanical properties of dissimilar metal-welded joint materials are heterogeneous, which is an obstacle to the safety evaluation of key welded structures. The variation of stress–strain conditions at the crack tip caused by mismatch of material mechanical properties in dissimilar metal-welded joints is an important factor affecting crack propagation behavior. To understand the influence of uneven distribution of ultimate strength of the base metal and the welded metal on the crack propagation path, fracture toughness, as well as the mechanical field at the crack tip in the small-scale yield range, the user-defined field variable subroutine method is used to express continuous variation characteristics of welded joint ultimate strength in finite element software. In addition, the J-integral during crack propagation is calculated, and the effect of the ultimate strength on the J-integral and the stress field at the crack tip are analyzed. The results show that as the crack propagation direction is perpendicular to the direction of ultimate strength, the gradient of ultimate strength increases from |G(y)|= 50 to |G(y)|= 100 MPa/mm, the crack deflection angle increases by 0.018%, and the crack length increases by 1.46%. The fracture toughness of the material decreased slightly during crack propagation. Under the condition that the crack propagation direction is the same as the direction of ultimate strength, the crack propagation path is a straight line. As the gradient of ultimate strength increases from G(x) = 50 to G(x) = 100 MPa/mm, the crack propagation length decreases by 5.17%, and the slope of fracture toughness curve increases by 51.63%. On the contrary, as the crack propagates to the low ultimate strength side, the crack propagation resistance decreases, the ultimate strength gradient increases from G(x) = −100 to G(x) = −50 MPa/mm, and the slope of the fracture toughness curve decreases by 51.01%. It is suggested to consider the relationship between crack growth behavior and ultimate strength when designing and evaluating the structural integrity of cracks at the material interface of dissimilar metal-welded joints.