Cargando…

A Wavelength Modulation Spectroscopy-Based Methane Flux Sensor for Quantification of Venting Sources at Oil and Gas Sites

An optical sensor employing tunable diode laser absorption spectroscopy with wavelength modulation and 2f harmonic detection was designed, prototyped, and tested for applications in quantifying methane emissions from vent sources in the oil and gas sector. The methane absorption line at 6026.23 cm(–...

Descripción completa

Detalles Bibliográficos
Autores principales: Festa-Bianchet, Simon A., Seymour, Scott P., Tyner, David R., Johnson, Matthew R.
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2022
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9185548/
https://www.ncbi.nlm.nih.gov/pubmed/35684796
http://dx.doi.org/10.3390/s22114175
_version_ 1784724748130844672
author Festa-Bianchet, Simon A.
Seymour, Scott P.
Tyner, David R.
Johnson, Matthew R.
author_facet Festa-Bianchet, Simon A.
Seymour, Scott P.
Tyner, David R.
Johnson, Matthew R.
author_sort Festa-Bianchet, Simon A.
collection PubMed
description An optical sensor employing tunable diode laser absorption spectroscopy with wavelength modulation and 2f harmonic detection was designed, prototyped, and tested for applications in quantifying methane emissions from vent sources in the oil and gas sector. The methane absorption line at 6026.23 cm(–1) (1659.41 nm) was used to measure both flow velocity and methane volume fraction, enabling direct measurement of the methane emission rate. Two configurations of the sensor were designed, tested, and compared; the first used a fully fiber-coupled cell with multimode fibers to re-collimate the laser beams, while the second used directly irradiated photodetectors protected by Zener barriers. Importantly, both configurations were designed to enable measurements within regulated Class I / Zone 0 hazardous locations, in which explosive gases are expected during normal operations. Controlled flows with methane volume fractions of 0 to 100% and a velocity range of 0 to 4 m/s were used to characterize sensor performance at a 1 Hz sampling rate. The measurement error in the methane volume fraction was less than 10,000 ppm (1%) across the studied range for both configurations. The short-term velocity measurement error with pure methane was <0.3 m/s with a standard deviation of 0.14 m/s for the fiber-coupled configuration and <0.15 m/s with a standard deviation of 0.07 m/s for the directly irradiated detector configuration. However, modal noise in the multimode fibers of the first configuration contributed to an unstable performance that was highly sensitive to mechanical disturbances. The second configuration showed good potential for an industrial sensor, successfully quantifying methane flow rates up to 11 kg/h within ±2.1 kg/h at 95% confidence over a range of methane fractions from 25–100%, and as low as ±0.85 kg/h in scenarios where the source methane fraction is initially unknown within this range and otherwise invariant.
format Online
Article
Text
id pubmed-9185548
institution National Center for Biotechnology Information
language English
publishDate 2022
publisher MDPI
record_format MEDLINE/PubMed
spelling pubmed-91855482022-06-11 A Wavelength Modulation Spectroscopy-Based Methane Flux Sensor for Quantification of Venting Sources at Oil and Gas Sites Festa-Bianchet, Simon A. Seymour, Scott P. Tyner, David R. Johnson, Matthew R. Sensors (Basel) Article An optical sensor employing tunable diode laser absorption spectroscopy with wavelength modulation and 2f harmonic detection was designed, prototyped, and tested for applications in quantifying methane emissions from vent sources in the oil and gas sector. The methane absorption line at 6026.23 cm(–1) (1659.41 nm) was used to measure both flow velocity and methane volume fraction, enabling direct measurement of the methane emission rate. Two configurations of the sensor were designed, tested, and compared; the first used a fully fiber-coupled cell with multimode fibers to re-collimate the laser beams, while the second used directly irradiated photodetectors protected by Zener barriers. Importantly, both configurations were designed to enable measurements within regulated Class I / Zone 0 hazardous locations, in which explosive gases are expected during normal operations. Controlled flows with methane volume fractions of 0 to 100% and a velocity range of 0 to 4 m/s were used to characterize sensor performance at a 1 Hz sampling rate. The measurement error in the methane volume fraction was less than 10,000 ppm (1%) across the studied range for both configurations. The short-term velocity measurement error with pure methane was <0.3 m/s with a standard deviation of 0.14 m/s for the fiber-coupled configuration and <0.15 m/s with a standard deviation of 0.07 m/s for the directly irradiated detector configuration. However, modal noise in the multimode fibers of the first configuration contributed to an unstable performance that was highly sensitive to mechanical disturbances. The second configuration showed good potential for an industrial sensor, successfully quantifying methane flow rates up to 11 kg/h within ±2.1 kg/h at 95% confidence over a range of methane fractions from 25–100%, and as low as ±0.85 kg/h in scenarios where the source methane fraction is initially unknown within this range and otherwise invariant. MDPI 2022-05-31 /pmc/articles/PMC9185548/ /pubmed/35684796 http://dx.doi.org/10.3390/s22114175 Text en © 2022 by the authors. https://creativecommons.org/licenses/by/4.0/Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).
spellingShingle Article
Festa-Bianchet, Simon A.
Seymour, Scott P.
Tyner, David R.
Johnson, Matthew R.
A Wavelength Modulation Spectroscopy-Based Methane Flux Sensor for Quantification of Venting Sources at Oil and Gas Sites
title A Wavelength Modulation Spectroscopy-Based Methane Flux Sensor for Quantification of Venting Sources at Oil and Gas Sites
title_full A Wavelength Modulation Spectroscopy-Based Methane Flux Sensor for Quantification of Venting Sources at Oil and Gas Sites
title_fullStr A Wavelength Modulation Spectroscopy-Based Methane Flux Sensor for Quantification of Venting Sources at Oil and Gas Sites
title_full_unstemmed A Wavelength Modulation Spectroscopy-Based Methane Flux Sensor for Quantification of Venting Sources at Oil and Gas Sites
title_short A Wavelength Modulation Spectroscopy-Based Methane Flux Sensor for Quantification of Venting Sources at Oil and Gas Sites
title_sort wavelength modulation spectroscopy-based methane flux sensor for quantification of venting sources at oil and gas sites
topic Article
url https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9185548/
https://www.ncbi.nlm.nih.gov/pubmed/35684796
http://dx.doi.org/10.3390/s22114175
work_keys_str_mv AT festabianchetsimona awavelengthmodulationspectroscopybasedmethanefluxsensorforquantificationofventingsourcesatoilandgassites
AT seymourscottp awavelengthmodulationspectroscopybasedmethanefluxsensorforquantificationofventingsourcesatoilandgassites
AT tynerdavidr awavelengthmodulationspectroscopybasedmethanefluxsensorforquantificationofventingsourcesatoilandgassites
AT johnsonmatthewr awavelengthmodulationspectroscopybasedmethanefluxsensorforquantificationofventingsourcesatoilandgassites
AT festabianchetsimona wavelengthmodulationspectroscopybasedmethanefluxsensorforquantificationofventingsourcesatoilandgassites
AT seymourscottp wavelengthmodulationspectroscopybasedmethanefluxsensorforquantificationofventingsourcesatoilandgassites
AT tynerdavidr wavelengthmodulationspectroscopybasedmethanefluxsensorforquantificationofventingsourcesatoilandgassites
AT johnsonmatthewr wavelengthmodulationspectroscopybasedmethanefluxsensorforquantificationofventingsourcesatoilandgassites