Cargando…

Naringenin Ultrafine Powder Was Prepared by a New Anti-Solvent Recrystallization Method

Raw naringenin directly isolated from plants is significantly limited by its poor dissolution rate and low bioavailability for clinical and in vivo studies. This study reported a method for the preparation of naringenin ultrafine powder (NUP) using a novel anti-solvent recrystallization process; pre...

Descripción completa

Detalles Bibliográficos
Autores principales: Zhang, Xiaonan, Huang, Yan, Shi, Yufei, Chen, Mengyu, Zhang, Lubin, An, Yimin, Liu, Zhiwei
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2022
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9231401/
https://www.ncbi.nlm.nih.gov/pubmed/35745448
http://dx.doi.org/10.3390/nano12122108
Descripción
Sumario:Raw naringenin directly isolated from plants is significantly limited by its poor dissolution rate and low bioavailability for clinical and in vivo studies. This study reported a method for the preparation of naringenin ultrafine powder (NUP) using a novel anti-solvent recrystallization process; preliminary experiments were conducted using six single-factor experiments. The response surface Box–Behnken (BBD) design was used to optimize the level of factors. The optimal preparation conditions of the DMP were obtained as follows: the feed rate was 40.82 mL/min, the solution concentration was 20.63 mg/mL, and the surfactant ratio was 0.62%. The minimum average particle size was 305.58 ± 0.37 nm in the derived optimum conditions. A scanning electron microscope was used to compare and analyze the appearance and morphology of the powder before and after preparation. The characterization results of FTIR, TG and XRD showed that no chemical change occurred in the powder before and after preparation. Through the simulated gastrointestinal juice digestion experiment, it was confirmed that the absorption rate of NUP was 2.96 times and 4.05 times higher than raw naringenin, respectively. Therefore, the results showed that the reduction in the particle size through the use of low-speed recrystallization could improve the absorption rate and provided a feasible approach for the further applications.