Blind testing in firearms: Preliminary results from a blind quality control program

Open proficiency tests meet accreditation requirements and measure examiner competence but may not represent actual casework. In December 2015, the Houston Forensic Science Center began a blind quality control program in firearms examination. Mock cases are created to mimic routine casework so that examiners are unaware they are being tested. Once the blind case is assigned to an examiner, the evidence undergoes microscopic examination and comparison to determine whether the fired evidence submitted was fired in the same firearm. Fifty‐one firearms blind cases resulting in 570 analysis and comparison determinations were reported between December 2015 and June 2021. No unsatisfactory results were obtained; however, 40.3% of comparisons in which the ground truth was either elimination or identification resulted in inconclusive conclusions. Due to the quality of some of the evidence submitted, inconclusive results were not unexpected. A ground truth of elimination and comparison result of inconclusive was observed at a rate of 74%, while a ground truth of identification and comparison result of inconclusive was observed at a rate of 31%. Bullets (61.8%) were the main contributors to inconclusive conclusions; variables such as the assigned examiners, training program, examiner experience, and the intended complexity of the case did not significantly contribute to the results. The program demonstrates that the quality management system and firearms section procedures can obtain accurate and reliable results and provides examiners added confidence in court. Additionally, the program can be tailored to target specific research questions and provide opportunities for collaboration with other laboratories and researchers.