Cargando…

Structure Characterization and Impact Effect of Al-Cu Graded Materials Prepared by Tape Casting

With the need of developing new materials, exploring new phenomenon, and discovering new mechanisms under extreme conditions, the response of materials to high-pressure compression attract more attention. However, the high-pressure state deviating from the Hugoniot line is difficult to realize by co...

Descripción completa

Detalles Bibliográficos
Autores principales:	Hu, Jianian, Tan, Ye, Li, Xuemei, Zhu, Youlin, Luo, Guoqiang, Zhang, Jian, Zhang, Ruizhi, Sun, Yi, Shen, Qiang, Zhang, Lianmeng
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2022
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9316280/ https://www.ncbi.nlm.nih.gov/pubmed/35888301 http://dx.doi.org/10.3390/ma15144834

Ejemplares similares

Design and Synthesis of C-O Grain Boundary Strengthening of Al Composites
por: Hu, Jianian, et al.
Publicado: (2020)

Hydrodynamic simulation of hypervelocity generation by multidimensional graded impactors: Planarity enhancement study
por: Guo, Chengcheng, et al.
Publicado: (2023)

Study on Rheological Behavior of Micro/Nano-Silicon Carbide Particles in Ethanol by Selecting Efficient Dispersants
por: Luo, Guoqiang, et al.
Publicado: (2020)

Microstructures and Macrosegregation of Al–Zn–Mg–Cu Alloy Billet Prepared by Uniform Direct Chill Casting
por: Zhou, Li, et al.
Publicado: (2021)

A Review on Mechanical Models for Cellular Media: Investigation on Material Characterization and Numerical Simulation
por: Luo, Guoqiang, et al.
Publicado: (2021)

Investigation of the Constitutive Model of W/PMMA Composite Microcellular Foams
por: Zhu, Yuxuan, et al.
Publicado: (2019)

Correlation Between the Structure and Compressive Property of PMMA Microcellular Foams Fabricated by Supercritical CO(2) Foaming Method
por: Zhang, Ruizhi, et al.
Publicado: (2020)

Peridynamics Model with Surface Correction Near Insulated Cracks for Transient Heat Conduction in Functionally Graded Materials
por: Tan, Yang, et al.
Publicado: (2020)

Effect of Multi-Source Ultrasonic on Segregation of Cu Elements in Large Al–Cu Alloy Cast Ingot
por: Peng, Hao, et al.
Publicado: (2019)

The Effect of the Cu Interlayer on the Interfacial Microstructure and Mechanical Properties of Al/Fe Bimetal by Compound Casting
por: Liu, Shiyuan, et al.
Publicado: (2023)

Effects of Cu/Er on Tensile Properties of Cast Al-Si Alloy at Low Temperature
por: Zhang, Huidi, et al.
Publicado: (2023)

Formation of strength platform in cast Al–Si–Mg–Cu alloys
por: Dong, Xixi, et al.
Publicado: (2019)

Microstructural Characterization of the As-Cast and Homogenized Al-Cu-Mg-Ag Alloy
por: Lin, Haitao, et al.
Publicado: (2023)

Long-Bone-Regeneration Process in a Sheep Animal Model, Using Hydroxyapatite Ceramics Prepared by Tape-Casting Method
por: Kresakova, Lenka, et al.
Publicado: (2023)

Microstructure and Mechanical Behaviors of Titanium Matrix Composites Containing In Situ Whiskers Synthesized via Plasma Activated Sintering
por: Sun, Yi, et al.
Publicado: (2018)

Intermetallics Formation during Solidification of Al-Si-Cu-Mg Cast Alloys
por: Mohamed, Adel M. A., et al.
Publicado: (2022)

Novel Fabrication Processing of Porous Al(2)O(3)/CaAl(12)O(19) Membrane by Combining Emulsion, Cement Curing and Tape-Casting Methods
por: Wang, Li, et al.
Publicado: (2022)

Effect of Al Content on the Microstructure and Properties of As-Cast Al(x)CoCrCuFe Alloys
por: Oliveira, B. S., et al.
Publicado: (2022)

Influence of cerium content on the microstructure and thermal expansion properties of suction cast Al-Cu-Fe alloys
por: Wang, Juan, et al.
Publicado: (2021)

Precipitation phenomena in Al-Zn-Mg alloy matrix composites reinforced with B(4)C particles
por: Wu, Chuandong, et al.
Publicado: (2017)

Effects of Trace Elements on the Microstructural and Machinability Characteristics of Al–Si–Cu–Mg Castings
por: Zedan, Yasser, et al.
Publicado: (2022)

Casting Simulation of Large-Volume Fluid Cementitious Materials: Effect of Material Properties and Casting Parameters
por: Wang, Junkai, et al.
Publicado: (2023)

Achievement of High Strength and Ductility in Al–Si–Cu–Mg Alloys by Intermediate Phase Optimization in As-Cast and Heat Treatment Conditions
por: Zhang, Bingrong, et al.
Publicado: (2020)

Effect of Intermetallics and Drill Materials on the Machinability of Al-Si Cast Alloys
por: Zedan, Yasser, et al.
Publicado: (2022)

Modification of a Defect-Based Fatigue Assessment Model for Al-Si-Cu Cast Alloys
por: Aigner, Roman, et al.
Publicado: (2018)

Synergistic Effects of La and Y on the Microstructure and Mechanical Properties of Cast Al-Si-Cu Alloys
por: Shuai, Luming, et al.
Publicado: (2022)

Effect of Aging Treatment on the Precipitation Behavior of a Novel Al-Cu-Zr Cast Alloy
por: Wei, Wu, et al.
Publicado: (2022)

Hot Deformation Behavior and Processing Maps of an As-Cast Al-5Mg-3Zn-1Cu (wt%) Alloy
por: Lei, Chuan, et al.
Publicado: (2023)

Study on bimetallic composites interface of Al/SiC(p)-Al matrix composites prepared by liquid-liquid compound casting
por: Shang, Yuncong, et al.
Publicado: (2023)

Eco-friendly p-type Cu(2)SnS(3) thermoelectric material: crystal structure and transport properties
por: Shen, Yawei, et al.
Publicado: (2016)

The Preparation of Monomer Casting Polyamide 6/Thermotropic Liquid Crystalline Polymer Composite Materials with Satisfactory Miscibility
por: Li, Mingmin, et al.
Publicado: (2022)

Research Progress on Multi-Component Alloying and Heat Treatment of High Strength and Toughness Al–Si–Cu–Mg Cast Aluminum Alloys
por: Zhang, Mingshan, et al.
Publicado: (2023)

Effect of Cu Content on the Precipitation Behaviors, Mechanical and Corrosion Properties of As-Cast Ti-Cu Alloys
por: Wang, Zhe, et al.
Publicado: (2022)

Microstructure and Mechanical Behavior of Quaternary Eutectic α+θ+Q+Si Clusters in As-Cast Al-Mg-Si-Cu Alloys
por: Li, Kai, et al.
Publicado: (2023)

In situ Neutron Diffraction during Casting: Determination of Rigidity Point in Grain Refined Al-Cu Alloys
por: Drezet, Jean-Marie, et al.
Publicado: (2014)

Effect of Minor Er Additions on the Microstructures and Mechanical Properties of Cast Al-Cu-Mg-Ag Alloys
por: Xie, Haoyu, et al.
Publicado: (2021)

Simultaneous increase in strength and ductility by decreasing interface energy between Zn and Al phases in cast Al-Zn-Cu alloy
por: Han, Seung Zeon, et al.
Publicado: (2017)

Rapid Spheroidization Process of S Phase (Al(2)CuMg) in the As-Cast 2024 Al Alloy Induced by High-Energy Electropulsing
por: Wei, Lai, et al.
Publicado: (2023)

Comparison of Two Types of Tapes for Taping After Breast Reconstruction Using Silicone Materials
por: Ishii, Naohiro, et al.
Publicado: (2021)

Fabrication and Characterization of High-Frequency Ultrasound Transducers Based on Lead-Free BNT-BT Tape-Casting Thick Film
por: Zhang, Junshan, et al.
Publicado: (2018)

Cannot write session to /tmp/vufind_sessions/sess_e5ducabnvp4ljee9m58ln38lv5