Cargando…

Prediction of Long-Term Tensile Properties of Glass Fiber Reinforced Composites under Acid-Base and Salt Environments

This study investigates the effects of deionized water, seawater, and solutions with various concentrations (5% and 10% by mass) of HCl and NaOH on the physical and mechanical properties of glass fiber reinforced polymers (GFRPs) through aging tests at 20 °C, 50 °C, and 80 °C. The tensile properties...

Descripción completa

Detalles Bibliográficos
Autores principales:	Zhu, Jihua, Deng, Yangjian, Chen, Piyu, Wang, Gang, Min, Hongguang, Fang, Wujun
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2022
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9331005/ https://www.ncbi.nlm.nih.gov/pubmed/35893995 http://dx.doi.org/10.3390/polym14153031

Ejemplares similares

Static and fatigue tensile properties of carbon/glass hybrid fiber-reinforced epoxy composites
por: Naito, Kimiyoshi
Publicado: (2022)

Tensile and Flexural Behaviors of Basalt Textile Reinforced Sprayed Glass Fiber Mortar Composites
por: Ates, Ali Osman, et al.
Publicado: (2023)

Effect of Strain Rate and Temperature on the Tensile Properties of Long Glass Fiber-Reinforced Polypropylene Composites
por: Wang, Qiaoyu, et al.
Publicado: (2023)

Mechanical Characterization of the Tensile Properties of Glass Fiber and Its Reinforced Polymer (GFRP) Composite under Varying Strain Rates and Temperatures
por: Ou, Yunfu, et al.
Publicado: (2016)

Residual Tensile Strength of the Multi-Impacted Scarf-Repaired Glass Fiber-Reinforced Polymer (GFRP) Composites
por: Kumari, Punita, et al.
Publicado: (2018)

Tensile Strength Prediction of Short Fiber Reinforced Composites
por: Huang, Zheng-Ming, et al.
Publicado: (2021)

Tensile Properties of In Situ 3D Printed Glass Fiber-Reinforced PLA
por: Ismail, Khairul Izwan, et al.
Publicado: (2023)

Failure Mechanisms and Reinforcing Modes of Ply Splice Fiber-Reinforced Composite Laminates under Tensile Load
por: Zhu, Meng, et al.
Publicado: (2019)

Tensile Properties of Composite Reinforced with Three-Dimensional Printed Fibers
por: Agarwal, Komal, et al.
Publicado: (2020)

Simplified FE model and experimental study on the tensile properties of the glass fiber reinforced polyester polymer
por: Zakki, Ahmad Fauzan, et al.
Publicado: (2022)

Tensile Creep Behavior of Quasi-Unidirectional E-Glass Fabric Reinforced Polypropylene Composite
por: Zhai, Zhanyu, et al.
Publicado: (2018)

Dynamic Mechanical Behavior Analysis of Flax/Jute Fiber-Reinforced Composites under Salt-Fog Spray Environment
por: Fiore, Vincenzo, et al.
Publicado: (2020)

Influence of Unit Cell Size and Fiber Packing on the Transverse Tensile Response of Fiber Reinforced Composites
por: D’Mello, Royan J., et al.
Publicado: (2019)

Effect of Fiber Blending Ratio on the Tensile Properties of Steel Fiber Hybrid Reinforced Cementitious Composites under Different Strain Rates
por: Son, Minjae, et al.
Publicado: (2021)

Effect of Glass Fiber Hybridization on the Durability in Salt-Fog Environment of Pinned Flax Composites
por: Fiore, Vincenzo, et al.
Publicado: (2021)

Efficient Depolymerization of Glass Fiber Reinforced PET Composites
por: Rubio Arias, Jose Jonathan, et al.
Publicado: (2022)

Experimental Analysis of Fiber Reinforcement Rings’ Effect on Tensile and Flexural Properties of Onyx™–Kevlar(®) Composites Manufactured by Continuous Fiber Reinforcement
por: Moreno-Núñez, Benjamín Alberto, et al.
Publicado: (2023)

Tribo-Mechanical Investigation of Glass Fiber Reinforced Polymer Composites under Dry Conditions
por: Birleanu, Corina, et al.
Publicado: (2023)

Effect of Stochastic Loading on Tensile Damage and Fracture of Fiber-Reinforced Ceramic-Matrix Composites
por: Li, Longbiao
Publicado: (2020)

Fabrication, Tensile Properties, and Photodecomposition of Basalt Fiber-Reinforced Cellulose Acetate Matrix Composites
por: Shen, Yuxi, et al.
Publicado: (2021)

Influence of Polymer Matrices on the Tensile and Impact Properties of Long Fiber-Reinforced Thermoplastic Composites
por: Jiang, Lijuan, et al.
Publicado: (2023)

Study on Axial Compression Behavior of Concrete Short Columns Confined by Flax/Glass Fiber Hybrid-Reinforced Epoxy Resin Composites
por: Yang, Lanjie, et al.
Publicado: (2022)

The Long-Term Interfacial Evolution and Prediction of Carbon- and Glass-Fiber-Reinforced Epoxy Hybrid Rods under a Hygrothermal Environment
por: Liu, Xiaodong, et al.
Publicado: (2023)

Electromechanical Response of High-Performance Fiber-Reinforced Cementitious Composites Containing Milled Glass Fibers under Tension
por: Kim, Min Kyoung, et al.
Publicado: (2018)

Investigation of the Failure Modes of Textile-Reinforced Concrete and Fiber/Textile-Reinforced Concrete under Uniaxial Tensile Tests
por: Mattarollo, Giorgio, et al.
Publicado: (2023)

Shrinkage Optimization in Talc- and Glass-Fiber-Reinforced Polypropylene Composites
por: Ryu, Youngjae, et al.
Publicado: (2019)

Crystallization Behavior and Properties of Glass Fiber Reinforced Polypropylene Composites
por: Wang, Yuming, et al.
Publicado: (2019)

Residual Tensile Properties and Explosive Spalling of High-Performance Fiber-Reinforced Cementitious Composites Exposed to Thermal Damage
por: Park, Gang-Kyu, et al.
Publicado: (2021)

Tensile Strength Analysis of Thin-Walled Polymer Glass Fiber Reinforced Samples Manufactured by 3D Printing Technology
por: Bochnia, Jerzy, et al.
Publicado: (2020)

Physico-Mechanical Properties of the Poly(oxymethylene) Composites Reinforced with Glass Fibers under Dynamical Loading
por: Kuciel, Stanisław, et al.
Publicado: (2019)

Toughening Mechanism Analysis of Recycled Rubber-Based Composites Reinforced with Glass Bubbles, Glass Fibers and Alumina Fibers
por: Kabakci, Gamze Cakir, et al.
Publicado: (2021)

Experimental Investigation on Dynamic Tensile Behaviors of Engineered Cementitious Composites Reinforced with Steel Grid and Fibers
por: Li, Liang, et al.
Publicado: (2021)

Modeling the Tensile Behavior of Fiber-Reinforced Strain-Hardening Cement-Based Composites: A Review
por: Ribeiro, Paula de Oliveira, et al.
Publicado: (2023)

Splitting Tensile Strength of Cement Soil Reinforced with Basalt Fibers
por: Wang, Shengnian, et al.
Publicado: (2020)

Experimental and Numerical Investigation of the Tensile and Failure Response of Multiple-Hole-Fiber-Reinforced Magnesium Alloy Laminates under Various Temperature Environments
por: Lin, Zhongzhao, et al.
Publicado: (2023)

Thermal Aging Effects on the Mechanical Behavior of Glass-Fiber-Reinforced Polyphenylene Sulfide Composites
por: Deng, Jiangang, et al.
Publicado: (2022)

A Study on Hot Stamping Formability of Continuous Glass Fiber Reinforced Thermoplastic Composites
por: Zhao, Feng, et al.
Publicado: (2022)

Tensile Behavior Characteristics of High-Performance Slurry-Infiltrated Fiber-Reinforced Cementitious Composite with Respect to Fiber Volume Fraction
por: Kim, Seungwon, et al.
Publicado: (2019)

Effective Tensile Strength Estimation of Natural Fibers through Micromechanical Models: The Case of Henequen Fiber Reinforced-PP Composites
por: Espinach, Francesc Xavier, et al.
Publicado: (2022)

Mechanical Behavior of Hybrid Glass/Steel Fiber Reinforced Epoxy Composites
por: McBride, Amanda K., et al.
Publicado: (2017)

Cannot write session to /tmp/vufind_sessions/sess_ffl2vcbjbc1jbn6dq0k2144t0p