Embolization using patient-specific vascular models created by a 3D printer for difficult cases: a report of two cases

With the widespread use of three-dimensional printers, organ models created by these printers are now being used in the medical field for preoperative planning of surgeries. In this article, we report two cases in which embolization was expected to be difficult, and the three-dimensional printer-based vascular modeling was helpful in planning the surgery. The first case involved an aneurysm of the splenic artery. We attempted to embolize the aneurysm but were unable to advance the catheter into the distal artery and discontinued the procedure. The second case was a perianal varicose vein, which was initially treated with percutaneous transhepatic obliteration but was recanalized and required embolization. However, we expected difficulty in selecting the inferior mesenteric vein. In both cases, the vascular models were created using a 3D printer from the patients’ computed tomography images. Preoperative planning, including treatment simulation, was based on these models. The time required to print a three-dimensional vascular model was approximately 12 hours at a cost of less than $10 each. Patient-specific vascular models using a three-dimensional printer can be a simple and inexpensive tool that can increase the success of embolization in difficult cases.