Cargando…
The Effect of Tin on Microstructure and Properties of the Al-10 wt.% Si Alloy
In this paper, the results from studies regarding near-eutectic Al-Si alloys with Sn as an alloying addition are presented. In most Al-Si alloys, tin is regarded as a contaminant; thus, its amount is limited to up to 0.3 wt.%. The few studies that can be found in the literature regarding the behavio...
Autores principales: | Kozana, Janusz, Piękoś, Marcin, Garbacz-Klempka, Aldona, Perek-Nowak, Małgorzata |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2022
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9505586/ https://www.ncbi.nlm.nih.gov/pubmed/36143656 http://dx.doi.org/10.3390/ma15186350 |
Ejemplares similares
-
Experimental Investigation and Thermodynamic Modeling of Influence of Nickel and Titanium Content on the Structure and Selected Properties of Tin Bronzes
por: Kozana, Janusz, et al.
Publicado: (2021) -
Shape-Dependent Strength of Al Si9Cu3FeZn Die-Cast Alloy in Impact Zone of Conformal Cooling Core
por: Piekło, Jarosław, et al.
Publicado: (2022) -
Effects of the Mg/Si Ratio on Microstructure, Mechanical Properties, and Precipitation Behavior of Al–Mg–Si–1.0 wt %-Zn Alloys
por: Li, Yong, et al.
Publicado: (2018) -
Effect of Ti Addition on the Microstructure and Mechanical Properties of SiC Matrix Composites Infiltrated by Al–Si (10 wt.%)–xTi Alloy
por: Yu, Yajun, et al.
Publicado: (2019) -
Use of Maraging Steel 1.2709 for Implementing Parts of Pressure Mold Devices with Conformal Cooling System
por: Piekło, Jarosław, et al.
Publicado: (2020)