Cargando…

Effect of Cold-Rolling Reduction on Recrystallization Microstructure, Texture and Corrosion Properties of the X2CrNi12 Ferritic Stainless Steel

X2CrNi12 ferritic stainless steel has a wide range of application prospects in the railway transportation, construction, and automobile fields due to its excellent properties. The properties of X2CrNi12 ferritic stainless steel can be further improved by cold-rolling and subsequent annealing treatme...

Descripción completa

Detalles Bibliográficos
Autores principales:	Li, Rui, Fu, Binguo, Wang, Yufeng, Li, Jingkun, Dong, Tianshun, Li, Guolu, Zhang, Guixian, Liu, Jinhai
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2022
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9571781/ https://www.ncbi.nlm.nih.gov/pubmed/36234254 http://dx.doi.org/10.3390/ma15196914

Ejemplares similares

Effect of Cu Content on the Precipitation Behaviors, Mechanical and Corrosion Properties of As-Cast Ti-Cu Alloys
por: Wang, Zhe, et al.
Publicado: (2022)

Influence of heat treatment on the mechanical properties of CrNi stainless steel orthodontic wires
por: Sepúlveda, Clariana Hoehne, et al.
Publicado: (2019)

Effect of Y Content on Precipitation Behavior, Oxidation and Mechanical Properties of As-Cast High-Temperature Titanium Alloys
por: Shen, Jiafeng, et al.
Publicado: (2023)

Effect of Reduction Sequence during Rolling on Deformed Texture and Anisotropy of Ferritic Stainless Steel
por: Cho, Sang Heon, et al.
Publicado: (2023)

Assessment of Corrosion Resistance and Hardness of Shot Peened X5CrNi18-10 Steel
por: Walczak, Mariusz, et al.
Publicado: (2022)

Investigation of Stress Corrosion Cracking Resistance of Irradiated 12Cr Ferritic-Martensitic Stainless Steel in Supercritical Water Environment
por: Margolin, Boris, et al.
Publicado: (2023)

Tailoring One-Pass Asymmetric Rolling of Extra Low Carbon Steel for Shear Texture and Recrystallization
por: Dhinwal, Satyaveer Singh, et al.
Publicado: (2019)

Effect of Cold-Rolling Directions on Recrystallization Texture Evolution of Pure Iron
por: Ogawa, Toshio, et al.
Publicado: (2022)

Effect of Nb Content on Cyclic Oxidation Behavior of As-Cast Ti-1100 Alloys
por: Song, Yingjun, et al.
Publicado: (2020)

Textural, Microstructural and Chemical Characterization of Ferritic Stainless Steel Affected by the Gold Dust Defect
por: Amaya Dolores, Beatriz, et al.
Publicado: (2023)

Effect of chromium content on the corrosion resistance of ferritic stainless steels in sulfuric acid solution
por: Yu, Yang, et al.
Publicado: (2018)

A High-Sensitivity Current Sensor Utilizing CrNi Wire and Microfiber Coils
por: Xie, Xiaodong, et al.
Publicado: (2014)

High-Temperature Oxidation Behavior of a Cu-Bearing 17Cr Ferritic Stainless Steel
por: Zhang, Mengqi, et al.
Publicado: (2020)

Corrosion of stainless steels /
por: Sedriks, A. John
Publicado: (1996)

Corrosion of stainless steels
por: Sedriks, A John
Publicado: (1996)

Morphology and Antibacterial Properties of Copper Precipitates in Ferrite Stainless Steel
por: Yin, Hongxiang, et al.
Publicado: (2021)

Corrosion resistance of stainless steels /
por: Dillon, C. P.
Publicado: (1995)

Improved Mechanical and Corrosion Properties of Powder Metallurgy Austenitic, Ferritic, and Martensitic Stainless Steels by Liquid Phase Sintering
por: Ku, Ming-Hsiang, et al.
Publicado: (2022)

Corrosion Resistance of AISI 442 and AISI 446 Ferritic Stainless Steels as a Support for PEMWE Bipolar Plates
por: Dan, Mircea Laurentiu, et al.
Publicado: (2023)

Effect of extremely high CO(2) pressure on the formation of the corrosion film on 13Cr stainless steel
por: Zhu, Jinyang, et al.
Publicado: (2019)

Antibacterial mechanism of Cu-bearing 430 ferritic stainless steel
por: Zhang, Zhuang, et al.
Publicado: (2021)

Complete Goss Secondary Recrystallization by Control of the Grain Size and Texture of Primary Recrystallization in Grain-Oriented Silicon Steel
por: Xu, Zhanyi, et al.
Publicado: (2021)

Three-Dimensional Analysis of Ferrite Grains Recrystallized in Low-Carbon Steel during Annealing
por: Horiuchi, Kengo, et al.
Publicado: (2021)

Low-Cycle Fatigue Behavior of 10CrNi3MoV High Strength Steel and Its Undermatched Welds
por: Song, Wei, et al.
Publicado: (2018)

Analysis of the Possibility of Plastic Deformation Characterisation in X2CrNi18-9 Steel Using Measurements of Electromagnetic Parameters
por: Roskosz, Maciej, et al.
Publicado: (2021)

Corrosion Properties of S-Phase/Cr(2)N Composite Coatings Deposited on Austenitic Stainless Steel
por: Fryska, Sebastian, et al.
Publicado: (2021)

Corrosion of stainless steels in supercritical water
por: Batelle Memorial Institute. Columbus, OH.
Publicado: (1956)

Effect of Solutionizing Duration and Temperature on the Electrochemical Corrosion and Pitting Resistance of Cold-Rolled Super Austenitic Stainless Steel
por: Adesina, Akeem Yusuf, et al.
Publicado: (2022)

Influence of Texture on Impact Toughness of Ferritic Fe-20Cr-5Al Oxide Dispersion Strengthened Steel
por: Sánchez-Gutiérrez, Javier, et al.
Publicado: (2017)

Deformation Behavior and Constitutive Model of 34CrNi3Mo during Thermo-Mechanical Deformation Process
por: Jia, Xiang-Dong, et al.
Publicado: (2022)

Numerical Simulation and Experimental Study on Residual Stress in the Curved Surface Forming of 12CrNi2 Alloy Steel by Laser Melting Deposition
por: Cui, Zhaoxing, et al.
Publicado: (2020)

Quenching and Tempering-Dependent Evolution on the Microstructure and Mechanical Performance Based on a Laser Additively Manufactured 12CrNi2 Alloy Steel
por: Zhang, Wei, et al.
Publicado: (2023)

Room temperature texturing of austenite/ferrite steel by electropulsing
por: Rahnama, Alireza, et al.
Publicado: (2017)

Superficial Grain Refinement of 316L Stainless Steel by Rolling with Rough Rolls
por: Maril, Yasmin, et al.
Publicado: (2023)

Grinding Force and Surface Formation Mechanisms of 17CrNi2MoVNb Alloy When Grinding with CBN and Alumina Wheels
por: Jiang, Xiaoyang, et al.
Publicado: (2023)

Electrochemical and passivation behavior investigation of ferritic stainless steel in simulated concrete pore media
por: Luo, Hong, et al.
Publicado: (2015)

Improving Plasticity of Ferritic Stainless Steel Welded Joints via Laser Spot Control
por: Gu, Lidong, et al.
Publicado: (2023)

Ultrasonic Assessment of the Influence of Cold Rolling and Recrystallization Annealing on the Elastic Constants in a TWIP Steel
por: Carvajal, Linton, et al.
Publicado: (2021)

Evolution of Grain Interfaces in Annealed Duplex Stainless Steel after Parallel Cross Rolling and Direct Rolling
por: Wang, Ming, et al.
Publicado: (2018)

Microstructure Evolution at Ni/Fe Interface in Dissimilar Metal Weld between Ferritic Steel and Austenitic Stainless Steel
por: Li, Xiaogang, et al.
Publicado: (2023)

Cannot write session to /tmp/vufind_sessions/sess_14ptljh6otp7f1rkhnheph80kp