Fabrication and Characterization of Hybrid Hole Transporting Layers of Organotin (IV) Semiconductors within Molybdenum Oxide/Poly(3,4-ethylenedyoxithiophene) Polystyrene Sulfonate Matrices

The hybrid film of molybdenum oxide (MoO(3)) and poly(3,4-ethylenedyoxithiophene) polystyrene sulfonate (PEDOT:PSS) is a promising candidate for use as hole transport layer (HTL) in low-cost devices. A fast, controllable and economic process was used to fabricate high-performance HTLs by adding organotin (IV) semiconductors to the MoO(3)/PEDOT:PSS films. These hybrid films were fabricated by spin-coating and the MoO(3)/PEDOT:PSS-organotin (IV) complex films were characterized by infrared spectroscopy, scanning electron microscopy (SEM) and atomic force microscopy (AFM). Some mechanical and optical properties of the hybrid films were obtained and, to electrically characterize the hybrid films, hetero-junction glass/ITO/MoO(3)/PEDOT:PSS-organotin (IV) complex/Ag devices were prepared. Regarding the mechanical properties, the films have high plastic deformation, with a maximum stress of around 40 MPa and a Knoop hardness of 0.14. With respect to optical behavior, the films showed high transparency, with optical gap values between 2.8 and 3.5 eV and an onset gap of around 2.4 eV, typical of semiconductors. Additionally, the films in their respective devices show ambipolar and ohmic behavior with small differences depending on the substituent in organotin (IV) semiconductors. The MoO(3)/PEDOT:PSS matrix defines the mechanical behavior of the films and the tin complexes contribute their optoelectronic properties.