Analysis of the Behavior of Fiberglass Composite Panels in Contact with Water Subjected to Repeated Impacts

One of the most common applications of glass fiber composite materials (GFRP) is the manufacturing of the hulls of high-speed boats. During navigation, the hull of these boats is subjected to repetitive impacts against the free surface of the water (slamming effect), which can cause severe damage to the material. To better understand the behavior of the composite material under this effect, in the present work, an experimental test has been carried out to reproduce the slamming phenomenon in GFRP panels by means of a novel device that allows this cyclic impact to be obtained while the panels are always in contact with water. By means of non-destructive ultrasound inspection in immersion, it has been possible to establish the evolution of the damage according to the number of impacts received by each panel. Destructive tests in the affected zone, specifically shear tests (Iosipescu test), allow determination of the loss of mechanical properties experienced by the material after receiving a high number of impacts in the presence of water (up to 900,000 impact cycles in some panels). The behavior of the material was found to be very different in wet and dry conditions. Under dry conditions, the material loses stiffness as the damage density increases and its shear strength also decreases, as does displacement at maximum load. For wet conditions, the material shows higher displacements at maximum load, while the shear strength decreases with increasing stiffness.