Cargando…

Low Cycle Fatigue of G20Mn5 Cast Steel Relation between Microstructure and Fatigue Life

Cast steel is commonly used to produce structural and safety parts. Foundry processes allow producing parts from scrap steel directly to the required dimensions without any forming operation. Cast components may, however, exhibit macro- and micro-shrinkage porosities. The combined effect of macro- a...

Descripción completa

Detalles Bibliográficos
Autores principales:	Bermond, Antonin, Roume, Claire, Stolarz, Jacques, Lenci, Matthieu, Carton, Jean-François, Klocker, Helmut
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2022
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9604811/ https://www.ncbi.nlm.nih.gov/pubmed/36295140 http://dx.doi.org/10.3390/ma15207072

Ejemplares similares

Balance Fatigue Design of Cast Steel Nodes in Tubular Steel Structures
por: Wang, Libin, et al.
Publicado: (2013)

Low-Cycle Fatigue Behavior of the Novel Steel and 30SiMn2MoV Steel at 700 °C
por: Zhao, Chao, et al.
Publicado: (2020)

Effect of Surface Finishing State on Fatigue Strength of Cast Aluminium and Steel Alloys
por: Oberreiter, Matthias, et al.
Publicado: (2023)

Microstructure, Tensile, and Fatigue Properties of Large-Scale Austenitic Lightweight Steel
por: Shin, Jong-Ho, et al.
Publicado: (2022)

Influence of Strain Gradient on Fatigue Life of Carbon Steel for Pressure Vessels in Low-Cycle and High-Cycle Fatigue Regimes
por: Fujii, Tomoyuki, et al.
Publicado: (2022)

Bending Fatigue Behavior of 316L Stainless Steel up to Very High Cycle Fatigue Regime
por: Hu, Yongtao, et al.
Publicado: (2020)

Validation of Multiaxial Fatigue Strength Criteria on Specimens from Structural Steel in the High-Cycle Fatigue Region
por: Fojtík, František, et al.
Publicado: (2020)

A Constitutive Relationship between Fatigue Limit and Microstructure in Nanostructured Bainitic Steels
por: Mueller, Inga, et al.
Publicado: (2016)

Fatigue Crack Initiation Change of Cast AZ91 Magnesium Alloy from Low to Very High Cycle Fatigue Region
por: Fintová, Stanislava, et al.
Publicado: (2021)

Fatigue-Induced Evolution of AISI 310S Steel Microstructure after Electron Beam Treatment
por: Konovalov, Sergey, et al.
Publicado: (2020)

Thermo-Mechanical Fatigue Behavior and Resultant Microstructure Evolution in Al-Si 319 and 356 Cast Alloys
por: Liu, Kun, et al.
Publicado: (2023)

The Three-Dimensional Morphology and Distribution of CaS Inclusions in Continuous Casting Slab of Ni20Mn6 Steel
por: Chen, Jing, et al.
Publicado: (2020)

Understanding the effect of irradiation temperature on microstructural evolution of 20MnMoNi55 steel
por: Srivastava, A. P., et al.
Publicado: (2022)

Study of Microstructure and Fatigue in Aluminum/Steel Butt Joints Made by CMT Fusion-Brazing Technology
por: Fang, Yu, et al.
Publicado: (2022)

Microstructure and Fatigue Damage of 316L Stainless Steel Manufactured by Selective Laser Melting (SLM)
por: Wang, Zhentao, et al.
Publicado: (2021)

Gigacycle fatigue in high strength steels
por: Furuya, Yoshiyuki, et al.
Publicado: (2019)

Microstructure and Low-Cycle Fatigue Behavior of Al-9Si-4Cu-0.4Mg-0.3Sc Alloy with Different Casting States
por: Wang, Guanyi, et al.
Publicado: (2020)

The Effect of the β-Al(5)FeSi Phases on Microstructure, Mechanical and Fatigue Properties in A356.0 Cast Alloys with Higher Fe Content without Additional Alloying of Mn
por: Kuchariková, Lenka, et al.
Publicado: (2021)

Characterization of Microstructures and Fatigue Properties for Dual-Phase Pipeline Steels by Gleeble Simulation of Heat-Affected Zone
por: Zhao, Zuopeng, et al.
Publicado: (2019)

Remaining Life Assessment for Steel After Low-Cycle Fatigue by Surface Crack Image
por: Shi, Che-Si, et al.
Publicado: (2019)

Very High Cycle Fatigue Behavior of Additively Manufactured 316L Stainless Steel
por: Voloskov, Boris, et al.
Publicado: (2020)

Effect of Corroded Surface Morphology on Ultra-Low Cycle Fatigue of Steel Bridge Piers
por: Song, Fangyuan, et al.
Publicado: (2021)

Prediction of 316 stainless steel low-cycle fatigue life based on machine learning
por: Duan, Hongyan, et al.
Publicado: (2023)

Effect of Loading Frequency Ratio on Multiaxial Asynchronous Fatigue Failure of 30CrMnSiA Steel
por: Liu, Tianqi, et al.
Publicado: (2021)

Strength gradient enhances fatigue resistance of steels
por: Ma, Zhiwei, et al.
Publicado: (2016)

Dilatometric and Microstructural Study of Martensite Tempering in 4% Mn Steel
por: Grajcar, Adam, et al.
Publicado: (2020)

Microstructure and Mechanical Properties of the As-Cast and As-Homogenized Mg-Zn-Sn-Mn-Ca Alloy Fabricated by Semicontinuous Casting
por: Lu, Xing, et al.
Publicado: (2018)

Microstructure and Fatigue Behaviors of Dissimilar A6061/Galvannealed Steel Joints Fabricated by Friction Stir Spot Welding
por: Kumamoto, Koki, et al.
Publicado: (2021)

Microstructures and Fatigue Properties of High-Strength Low-Alloy Steel Prepared through Submerged-Arc Additive Manufacturing
por: Hu, Mei-Juan, et al.
Publicado: (2022)

Load Direction-Dependent Influence of Forming-Induced Initial Damage on the Fatigue Performance of 16MnCrS5 Steel
por: Moehring, Kerstin, et al.
Publicado: (2020)

High Cycle Fatigue Performance of LPBF 304L Stainless Steel at Nominal and Optimized Parameters
por: Parvez, Mohammad Masud, et al.
Publicado: (2020)

A Simplified Ductile Fracture Model for Predicting Ultra-Low Cycle Fatigue of Structural Steels
por: Yu, Mingming, et al.
Publicado: (2022)

Oxidation Damage Evolution in Low-Cycle Fatigue Life of Niobium-Stabilized Austenitic Stainless Steel
por: Choi, Wan-Kyu, et al.
Publicado: (2022)

Statistical Characterization of Strain-Controlled Low-Cycle Fatigue Behavior of Structural Steels and Aluminium Material
por: Bazaras, Žilvinas, et al.
Publicado: (2022)

Predictive model to design for high cycle fatigue of stainless steels produced by metal additive manufacturing
por: Serjouei, Ahmad, et al.
Publicado: (2022)

An Experimental Analysis of the High-Cycle Fatigue Fracture of H13 Hot Forging Tool Steels
por: Calvo-García, Erik, et al.
Publicado: (2022)

Effects of V-N Microalloying on Low-Cycle Fatigue Property in the Welded Joints of Constructional Steel
por: Cui, Kaiyu, et al.
Publicado: (2023)

Role of Reversed Austenite Behavior in Determining Microstructure and Toughness of Advanced Medium Mn Steel by Welding Thermal Cycle
por: Chen, Yunxia, et al.
Publicado: (2018)

Bending Fatigue Behaviour and Fatigue Endurance Limit Prediction of 20Cr2Ni4A Gear Steel after the Ultrasonic Surface Rolling Process
por: Wang, Zhiyuan, et al.
Publicado: (2021)

The Low-Cycle Fatigue Behavior, Microstructure Evolution, and Life Prediction of SS304: Influence of Temperature
por: Mei, Ting, et al.
Publicado: (2023)

Cannot write session to /tmp/vufind_sessions/sess_ptpk8ke7ehhblu7umi8qes2b5r