Cargando…

Effect of Varying Plasma Powers on High-Temperature Applications of Plasma-Sprayed Al(0.5)CoCrFeNi(2)Ti(0.5) Coatings

In this work, the microstructure and mechanical properties of atmospheric plasma-sprayed coatings of Al(0.5)CoCrFeNi(2)Ti(0.5,) prepared using gas-atomized powders at varying spray powers, are studied in as-sprayed and heat-treated conditions. Gas-atomized powders had spherical shapes and uniform el...

Descripción completa

Detalles Bibliográficos
Autores principales:	Rotich, Sammy Kiplangat, Kipkirui, Ngetich Gilbert, Lin, Tzu-Tang, Chen, Shih-Hsun
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2022
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9611188/ https://www.ncbi.nlm.nih.gov/pubmed/36295265 http://dx.doi.org/10.3390/ma15207198

Ejemplares similares

Al(0.5)CoCrFeNi(2) High Entropy Alloy Particle Reinforced AZ91 Magnesium Alloy-Based Composite Processed by Spark Plasma Sintering
por: Chiu, Chun, et al.
Publicado: (2021)

Effect of Cold Rolling on the Phase Transformation Kinetics of an Al(0.5)CoCrFeNi High-Entropy Alloy
por: Wang, Jun, et al.
Publicado: (2018)

Exchange bias effect in polycrystalline Bi(0.5)Sr(0.5)Fe(0.5)Cr(0.5)O(3) bulk
por: Li, S. Z., et al.
Publicado: (2023)

Dynamic Mechanical Properties and Microstructure of an (Al(0.5)CoCrFeNi)(0.95)Mo(0.025)C(0.025) High Entropy Alloy
por: Wang, Bingfeng, et al.
Publicado: (2019)

Magnetic properties of the complex concentrated alloy system CoFeNi(0.5)Cr(0.5)Al(x)
por: Morley, N. A., et al.
Publicado: (2020)

Microstructural Design of Ba(0.5)La(0.5)Co(0.5)Fe(0.5)O(3) Perovskite Ceramics
por: Gierszewska, Daria, et al.
Publicado: (2021)

Corrosion Behavior of CrFeCoNiV(0.5) and CrFeCoNiV Alloys in 0.5 M and 1 M Sodium Chloride Solutions
por: Tsau, Chun-Huei, et al.
Publicado: (2023)

Low-Temperature Sintering of Bi(Ni(0.5)Ti(0.5))O(3)-BiFeO(3)-Pb(Zr(0.5)Ti(0.5))O(3) Ceramics and Their Performance
por: Wang, Wuyang, et al.
Publicado: (2023)

Structural Insight into La(0.5)Ca(0.5)Mn(0.5)Co(0.5)O(3) Decomposition in the Methane Combustion Process
por: Nikolaeva, Olga, et al.
Publicado: (2021)

Crystal chemistry and compressibility of Fe(0.5)Mg(0.5)Al(0.5)Si(0.5)O(3) and FeMg(0.5)Si(0.5)O(3) silicate perovskites at pressures up to 95 GPa
por: Koemets, Iuliia, et al.
Publicado: (2023)

Near-infrared emitting CdTe(0.5)Se(0.5)/Cd(0.5)Zn(0.5)S quantum dots: synthesis and bright luminescence
por: Yang, Ping, et al.
Publicado: (2012)

Corrosion Resistance of Al(0.5)CoCrFeNiCu(x)Ag(y) (x = 0.25, 0.5; y = 0, 0.1) High-Entropy Alloys in 0.5M H(2)SO(4) Solution
por: Samoilova, Olga, et al.
Publicado: (2023)

Effect of FeCoNiCrCu(0.5) High-entropy-alloy Substrate on Sn Grain Size in Sn-3.0Ag-0.5Cu Solder
por: Shen, Yu-An, et al.
Publicado: (2019)

Effect of Oxygen-deficiencies on Resistance Switching in Amorphous YFe(0.5)Cr(0.5)O(3−d) films
por: Wang, Xianjie, et al.
Publicado: (2016)

High efficiency electrocatalyst of LaCr(0.5)Fe(0.5)O(3) nanoparticles on oxygen-evolution reaction
por: Gao, Xiaoping, et al.
Publicado: (2020)

Microstructure and Corrosion Behavior of (CoCrFeNi)(95)Nb(5) High-Entropy Alloy Coating Fabricated by Plasma Spraying
por: Wang, Wenrui, et al.
Publicado: (2019)

Microstructure of Ni(0.5)Zn(0.5)Fe(2)O(4) Nanofiber with Metal Nitrates in Electrospinning Precursor
por: Na, Kyeong-Han, et al.
Publicado: (2020)

Improved Electrochemical Performance of 0.5Li(2)MnO(3)·0.5LiNi(0.5)Mn(0.5)O(2) Cathode Materials for Lithium Ion Batteries Synthesized by Ionic-Liquid-Assisted Hydrothermal Method
por: Xiang, Yanhong, et al.
Publicado: (2020)

Annealing-Dependent Morphotropic Phase Boundary in the BiMg(0.5)Ti(0.5)O(3)–BiZn(0.5)Ti(0.5)O(3) Perovskite System
por: Cardoso, João Pedro V., et al.
Publicado: (2022)

New insights into defects and magnetic interactions inducing lattice disordering in Co(2)Fe(0.5)Cr(0.5)Al
por: Yadav, Ravi Kumar, et al.
Publicado: (2023)

Comparison of the efficacy of 0.5% isobaric bupivacaine, 0.5% levobupivacaine, and 0.5% hyperbaric bupivacaine for spinal anesthesia in lower limb surgeries
por: Piacherski, Valery, et al.
Publicado: (2023)

Efficacy and safety of 0.5% levobupivacaine versus 0.5% bupivacaine for peribulbar anesthesia
por: Pacella, Elena, et al.
Publicado: (2013)

Two-Step Solvothermal Synthesis of (Zn(0.5)Co(0.5)Fe(2)O(4)/Mn(0.5)Ni(0.5)Fe(2)O(4))@C-MWCNTs Hybrid with Enhanced Low Frequency Microwave Absorbing Performance
por: Yin, Pengfei, et al.
Publicado: (2019)

Author Correction: Effect of FeCoNiCrCu(0.5) High-entropy-alloy Substrate on Sn Grain Size in Sn-3.0Ag-0.5Cu Solder
por: Shen, Yu-An, et al.
Publicado: (2020)

Thick Film Ni(0.5)Mn(0.5−x)Sn(x) Heusler Alloys by Multi-layer Electrochemical Deposition
por: Zhang, Yijia, et al.
Publicado: (2018)

Anomalous Thermal Expansion of HoCo(0.5)Cr(0.5)O(3) Probed by X-ray Synchrotron Powder Diffraction
por: Hreb, Vasyl, et al.
Publicado: (2017)

Comparative Investigation of 0.5Li(2)MnO(3)·0.5LiNi(0.5)Co(0.2)Mn(0.3)O(2) Cathode Materials Synthesized by Using Different Lithium Sources
por: Wang, Peng-Bo, et al.
Publicado: (2018)

Microstructures, Hardness and Corrosion Behaviors of FeCoNiNb(0.5)Mo(0.5) and FeCoNiNb High-Entropy Alloys
por: Tsau, Chun-Huei, et al.
Publicado: (2017)

Synthesis and Characterization of LaNi(0.5)Ti(0.5)O(3) and La(2)NiTiO(6) Double Perovskite Nanoparticles
por: Córdova-Calderón, José, et al.
Publicado: (2022)

High-Temperature Wear Behaviour of Spark Plasma Sintered AlCoCrFeNiTi(0.5) High-Entropy Alloy
por: Löbel, Martin, et al.
Publicado: (2019)

Producing Soft Magnetic Composites by Spark Plasma Sintering of Pseudo Core–Shell Ni–Fe Alloy@Mn(0.5)Zn(0.5)Fe(2)O(4) Powders
por: Cotojman, Loredana, et al.
Publicado: (2023)

Electrochemical properties of La(0.5)Sr(0.5)Fe(0.95)Mo(0.05)O(3−δ) as cathode materials for IT-SOEC
por: Hou, Yunting, et al.
Publicado: (2021)

Dynamic Polarization Behaviors of Equimolar CoCrFeNi High-Entropy Alloy Compared with 304 Stainless Steel in 0.5 M H(2)SO(4) Aerated Aqueous Solution
por: Yen, Chao-Chun, et al.
Publicado: (2022)

Li(0.5)Al(0.5)Mg(2)(MoO(4))(3)
por: Ennajeh, Ines, et al.
Publicado: (2013)

0.5% levobupivacaine versus 0.5% ropivacaine: Are they different in ultrasound-guided sciatic block?
por: Pham Dang, Charles, et al.
Publicado: (2015)

Grain Refinement Mechanisms of TiC(0.5)N(0.5) Nanoparticles in Aluminum
por: Wang, Kui, et al.
Publicado: (2023)

Suppressed Growth of (Fe, Cr(,) Co(,) Ni(,) Cu)Sn(2) Intermetallic Compound at Interface between Sn-3.0Ag-0.5Cu Solder and FeCoNiCrCu(0.5) Substrate during Solid-state Aging
por: Shen, Yu-An, et al.
Publicado: (2019)

Enhanced Photocatalytic Hydrogen Evolution by Loading Cd(0.5)Zn(0.5)S QDs onto Ni(2)P Porous Nanosheets
por: Xiao, Lingfeng, et al.
Publicado: (2018)

Carbon nitride supported Ni(0.5)Co(0.5)O nanoparticles with strong interfacial interaction to enhance the hydrolysis of ammonia borane
por: Shang, Yunpeng, et al.
Publicado: (2019)

Electrical, dielectric properties and study of AC electrical conduction mechanism of Li(0.9)□(0.1)NiV(0.5)P(0.5)O(4)
por: Rahal, A., et al.
Publicado: (2018)

Cannot write session to /tmp/vufind_sessions/sess_ihiljcmok6vjcctjnre9r0ivni