Cargando…
Research on the Behavior of Stiffening Walls in Single-Storey Buildings Made of Autoclaved Aerated Concrete (AAC) Masonry Units
Experimental identification of stiffening walls is often limited to studying single-wall models. However, these samples do not reflect many additional effects—torsion of the building and redistribution of internal forces. This paper presents the results of two full-scale buildings made of autoclaved...
Autores principales: | Grzyb, Krzysztof, Jasiński, Radosław |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2022
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9612343/ https://www.ncbi.nlm.nih.gov/pubmed/36295469 http://dx.doi.org/10.3390/ma15207404 |
Ejemplares similares
-
Comparative Studies of the Confined Effect of Shear Masonry Walls Made of Autoclaved Aerated Concrete Masonry Units
por: Jasiński, Radosław, et al.
Publicado: (2023) -
Validation of Selected Non-Destructive Methods for Determining the Compressive Strength of Masonry Units Made of Autoclaved Aerated Concrete
por: Jasiński, Radosław, et al.
Publicado: (2019) -
Finite Element Study on the Shear Capacity of Traditional Joints between Walls Made of AAC Masonry Units
por: Kozłowski, Marcin, et al.
Publicado: (2020) -
Use of the AE Effect to Determine the Stresses State in AAC Masonry Walls under Compression
por: Jasiński, Radosław, et al.
Publicado: (2021) -
Fundamental Properties and Thermal Transferability of Masonry Built by Autoclaved Aerated Concrete Self-Insulation Blocks
por: Li, Fenglan, et al.
Publicado: (2020)