Impact of the downstream myocardial mass on values of coronary microvascular resistance

The assessment of hyperemic microvascular resistance (HMR) may be dependent on the assessment location in the coronary artery and the amount of partial myocardial mass (PMM) distal to the assessment locations. The aim of this study was to investigate the differences in HMR values between the distal and proximal sites in the same coronary arteries as well as the relationship between HMR and PMM. Twenty‐nine vessels from 26 patients who had undergone intracoronary physiological assessments including Doppler flow velocity at the distal third part and the proximal third part in the same vessels were assessed. The mean values of HMR and PMM at the distal sites were 2.08 ± 0.75 mmHg/cm/sec and 22.2 ± 10.4 g, respectively. At the proximal sites, the values of HMR and PMM were 1.19 ± 0.33 mmHg/cm/sec and 59.9 ± 18.3 g, respectively. All HMR values at the distal sites were significantly higher than those at the proximal sites (p < 0.001). Smaller PMM at the distal sites was significantly associated with higher HMR (r = −0.544, p = 0.002) and was the strongest factor affecting the HMR values (p = 0.009), while this relationship was not observed at the proximal sites (r = −0.262, p = 0.17). The impact of PMM on HMR was diminished at assessment locations where PMM was greater than 35 g. In conclusion, a small amount of downstream myocardial mass could be related to high HMR values. The assessment location around the proximal coronary artery with over 35 g of myocardium would be appropriate to assess HMR because it minimizes the influence of the assessment location.