Fabrication of Cu Micromembrane as a Flexible Electrode

A Cu micromembrane is successfully fabricated and validated as a porous flexible electrode. The Cu micromembrane is prepared by functionalizing individual polypropylene (PP) fibers in a polypropylene micromembrane (PPMM) using a mixture of polydopamine (PDA) and polyethyleneimine (PEI). The mixture of PDA and PEI provides adhesive, wetting, and reducing functionalities that facilitate subsequent Ag activation and Cu electroless plating. Scanning electron microscopy reveals conformal deposition of Cu on individual PP fibers. Porometer analysis indicates that the porous nature of PPMM is properly maintained. The Cu micromembrane demonstrates impressive electrical conductivities in both the X direction (1.04 ± 0.21 S/cm) and Z direction (2.99 ± 0.54 × 10(−3) S/cm). In addition, its tensile strength and strain are better than those of pristine PPMM. The Cu micromembrane is flexible and mechanically robust enough to sustain 10,000 bending cycles with moderate deterioration. Thermogravimetric analysis shows a thermal stability of 400 °C and an effective Cu loading of 5.36 mg/cm(2). Cyclic voltammetric measurements reveal that the Cu micromembrane has an electrochemical surface area of 277.8 cm(2) in a 1 cm(2) geometric area (a roughness factor of 227.81), a value that is 45 times greater than that of planar Cu foil.