Mechanism Analysis of Nanosecond Pulse Laser Etching of SiC(p)/Mg Composites

Due to the introduction of silicon carbide reinforcement, the physical and cutting properties of SiC(p)/Mg composites are very different from those of metal composites. Nanosecond pulse laser processing is more efficient than traditional processing for SiC(p)/Mg composites. A low-power pulsed fiber laser was used to etch 3.0 mm thick SiC(p)/Mg composites. The effect of low laser power (0~50 W) on the morphology and heat-affected zone of the SiC(p)/Mg composite after etching was studied. The results show that when the laser power increases, the material accumulation at the ablation end of the machining surface becomes more and more serious. With the increase in power, the differences in ablation width and ablation depth on the surface of composite materials do not increase proportionally. When the laser power increases gradually, the width of the heat-affected zone increases in the direction of the perpendicular laser beam and reaches the maximum value at the etched end.