Cargando…

Fabrication and Supercritical Water Corrosion Resistance of TiN/TiNC/Al(2)O(3) Multilayer Coating on Inconel 625 Alloy by CVD Method

A TiN/TiNC/Al(2)O(3) multilayer coating was deposited on an Inconel 625 alloy by the chemical vapor deposition method as a protective barrier to improve the corrosion resistance in supercritical water. The corrosion characteristics were evaluated in a reactor at 500 °C and 25 MPa for 72 h. The surfa...

Descripción completa

Detalles Bibliográficos
Autores principales:	Zhang, Zhidong, Pan, Yuelong, Guo, Hao, Zeng, Xiangcai, Shi, Qiwu, Lu, Tiecheng
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2022
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9657463/ https://www.ncbi.nlm.nih.gov/pubmed/36363262 http://dx.doi.org/10.3390/ma15217670

Ejemplares similares

The Structure and Properties of Laser-Cladded Inconel 625/TiC Composite Coatings
por: Poloczek, Tomasz, et al.
Publicado: (2023)

Effect of Iron Ion on Corrosion Behavior of Inconel 625 in High-Temperature Water
por: Zhou, Huiling, et al.
Publicado: (2020)

The temperature dependence of the surface composition of Inconel 600 and Inconel 625
por: Achard, M H, et al.
Publicado: (1976)

Sol–Gel-Derived Ni(3)Al Coating on Nickel Alloy for Oxidation Resistance in Supercritical Water Environments
por: Pan, Yuelong, et al.
Publicado: (2022)

Precipitates in Additively Manufactured Inconel 625 Superalloy
por: Dubiel, Beata, et al.
Publicado: (2019)

Case of Poisoning by Tinc: Aconite
por: Noble, William
Publicado: (1861)

Characterization of the Structure, Mechanical Properties and Erosive Resistance of the Laser Cladded Inconel 625-Based Coatings Reinforced by TiC Particles
por: Kotarska, Aleksandra, et al.
Publicado: (2021)

Effect of the Mass Fraction of NiTi–TiB(2) SHS-Particles on the Phase Composition, Structure, and Mechanical Properties of Inconel 625–NiTi–TiB(2) Composites Produced by Direct Laser Deposition
por: Matveev, Alexey, et al.
Publicado: (2022)

Effect of frequency on fretting wear behavior of Ti/TiN multilayer film on depleted uranium
por: Wu, Yan-Ping, et al.
Publicado: (2017)

Simulation of TTT Curves for Additively Manufactured Inconel 625
por: LINDWALL, G., et al.
Publicado: (2019)

Effect of MBF-20 Interlayer on the Microstructure and Corrosion Behaviour of Inconel 625 Super Alloy after Diffusion Brazing
por: Doroudi, Alireza, et al.
Publicado: (2023)

Processing of Bimetallic Inconel 625-16Mo3 Steel Tube via Supercritical Bend: Study of the Mechanical Properties and Structure
por: Barenyi, Igor, et al.
Publicado: (2023)

Mechanical and Microstructural Characterization of Arc-Welded Inconel 625 Alloy
por: Kotzem, Daniel, et al.
Publicado: (2019)

Corrosion and wear behaviour of highly porous Ti-TiB-TiN(x) in situ composites in simulated physiological solution
por: TOPTAN, Fatih
Publicado: (2020)

On the Use of Tinc. Ferr. Chlorid. in Uterine Hemorrhages
por: Schreier, Frederick
Publicado: (1856)

Low Friction CrN(MPP)/TiN(DCMS) Multilayer Coatings
por: Paulitsch, J., et al.
Publicado: (2012)

FEM-Based Thermogram Correction for Inconel 625 Joint Hardness Clustering
por: Jamrozik, Wojciech, et al.
Publicado: (2022)

Investigation of Strain Fatigue Behavior for Inconel 625 with Laser Shock Peening
por: Sun, Yaofei, et al.
Publicado: (2022)

Fretting Wear Behavior and Photoelectron Spectroscopy (XPS) Analysis of a Ti/TiN Multilayer Film Deposited on Depleted Uranium
por: Zhu, Shengfa, et al.
Publicado: (2018)

The Interface Microstructures and Mechanical Properties of Laser Additive Repaired Inconel 625 Alloy
por: Wei, Yiyun, et al.
Publicado: (2020)

Heating Conditions Influence on Solidification of Inconel 625–WC System for Additive Manufacturing
por: Huebner, Jan, et al.
Publicado: (2020)

Effect of Fe Content on Microstructure and Properties of Laser Cladding Inconel 625 Alloy
por: Liu, Weidong, et al.
Publicado: (2022)

Solid-State Transformation of an Additive Manufactured Inconel 625 Alloy at 700 °C
por: Zhang, Fan, et al.
Publicado: (2021)

The surface properties of Inconel 600 and Inconel 625 studied by Scanning Electron Microscopy, Auger Electron Spectroscopy and Ion Induced Desorption
por: Mathewson, A G
Publicado: (1976)

Corrosion and Wear Behavior of TiO(2)/TiN Duplex Coatings on Titanium by Plasma Electrolytic Oxidation and Gas Nitriding
por: Bakhtiari-Zamani, Hassan, et al.
Publicado: (2022)

Comparison Study of PVD Coatings: TiN/AlTiN, TiN and TiAlSiN Used in Wood Machining
por: Kucharska, Beata, et al.
Publicado: (2022)

Effect of Supercritical Bending on the Mechanical & Tribological Properties of Inconel 625 Welded Using the Cold Metal Transfer Method on a 16Mo3 Steel Pipe
por: Krbata, Michal, et al.
Publicado: (2023)

Corrosion Resistance of Inconel 625 CMT-Cladded Layers after Long-Term Exposure to Biomass and Waste Ashes in High-Temperature Conversion Processes
por: Błoniarz, Aleksandra, et al.
Publicado: (2020)

Highly Reliable Ovonic Threshold Switch with TiN/GeTe/TiN Structure
por: Seong, Dongjun, et al.
Publicado: (2023)

Investigation of microstructure in additive manufactured Inconel 625 by spatially resolved neutron transmission spectroscopy
por: Tremsin, Anton S., et al.
Publicado: (2016)

Grain-Boundary Interaction between Inconel 625 and WC during Laser Metal Deposition
por: Huebner, Jan, et al.
Publicado: (2018)

Study of the Dynamic Recrystallization Process of the Inconel625 Alloy at a High Strain Rate
por: Jia, Zhi, et al.
Publicado: (2019)

High Strain Rate Yielding of Additive Manufacturing Inconel 625 by Selective Laser Melting
por: Du, Kang, et al.
Publicado: (2021)

A TiN@C core–shell support for improving Pt catalyst corrosion resistance
por: Zhang, Hongyu, et al.
Publicado: (2022)

Preparation of Ti, Ti/TiC or Ti/TiN based hollow fibres with extremely low electrical resistivity
por: Jong, Ronald P. H., et al.
Publicado: (2020)

Quad-Level Cell Switching with Excellent Reliability in TiN/AlOx:Ti/TaOx/TiN Memory Device
por: Shin, Hee Ju, et al.
Publicado: (2022)

TiN/Ti/HfO(2)/TiN memristive devices for neuromorphic computing: from synaptic plasticity to stochastic resonance
por: Maldonado, David, et al.
Publicado: (2023)

Data on the influence of TiN on wear and corrosion behavior of Ti–6Al–4V alloy fabricated through spark plasma sintering
por: Kgoete, F.M., et al.
Publicado: (2018)

Oxidation Behavior of Multilayer Hard Coatings (TiCN/Al(2)O(3)/TiN) in Process of Recycling Coated Multicomponent Hardmetal Scrap
por: Kuang, Hai, et al.
Publicado: (2018)

SEM/TEM Investigation of Aluminide Coating Co-Doped with Pt and Hf Deposited on Inconel 625
por: Morgiel, Jerzy, et al.
Publicado: (2018)

Cannot write session to /tmp/vufind_sessions/sess_erhl17t1bsoqp93nlh2l0sd3cb