Risk Factors and Corresponding Management for Suture Anchor Pullout during Arthroscopic Rotator Cuff Repair

Introduction: Due to the aging of the population, the incidence of rotator cuff tears is growing. For rotator cuff repair, arthroscopic suture-anchor repair has gradually replaced open transosseous repair, so suture anchors are now considered increasingly important in rotator cuff tear reconstruction. There are some but limited studies of suture anchor pullout after arthroscopic rotator cuff repair. However, there is no body of knowledge in this area, which makes it difficult for clinicians to predict the risk of anchor pullout comprehensively and manage it accordingly. Methods: The literature search included rotator cuff repair as well as anchor pullout strength. A review of the literature was performed including all articles published in PubMed until September 2021. Articles of all in vitro biomechanical and clinical trial levels in English were included. After assessing all abstracts (n = 275), the full text and the bibliographies of the relevant articles were analyzed for the questions posed (n = 80). Articles including outcomes without the area of interest were excluded (n = 22). The final literature research revealed 58 relevant articles. Narrative synthesis was undertaken to bring together the findings from studies included in this review. Result: Based on the presented studies, the overall incidence of anchor pullout is not low, and the incidence of intraoperative anchor pullout is slightly higher than in the early postoperative period. The risk factors for anchor pullout are mainly related to bone quality, insertion depth, insertion angle, size of rotator cuff tear, preoperative corticosteroid injections, anchor design, the materials used to produce anchors, etc. In response to the above issues, we have introduced and evaluated management techniques. They include changing the implant site of anchors, cement augmentation for suture anchors, increasing the number of suture limbs, using all-suture anchors, using an arthroscopic transosseous knotless anchor, the Buddy anchor technique, Steinmann pin anchoring, and transosseous suture repair technology. Discussion: However, not many of the management techniques have been widely used in clinical practice. Most of them come from in vitro biomechanical studies, so in vivo randomized controlled trials with larger sample sizes are needed to see if they can help patients in the long run.