Green and Sustainable Hot Melt Adhesive (HMA) Based on Polyhydroxyalkanoate (PHA) and Silanized Cellulose Nanofibers (SCNFs)

Polyhydroxyalkanoate (PHA), with a long chain length and high poly(4–hydroxybutyric acid) (P4HB) ratio, can be used as a base polymer for eco-friendly and biodegradable adhesives owing to its high elasticity, elongation at break, flexibility, and processability; however, its molecular structures must be adjusted for adhesive applications. In this study, surface-modified cellulose nanofibers (CNFs) were used as a hydrophobic additive for the PHA-based adhesive. For the surface modification of CNFs, double silanization using tetraethyl orthosilicate (TEOS) and methyltrimethoxysilane (MTMS) was performed, and the thermal and structural properties were evaluated. The hydrophobicity of the TEOS- and MTMS-treated CNFs (TMCNFs) was confirmed by FT-IR and water contact angle analysis, with hydrophobic CNFs well dispersed in the PHA. The PHA–CNFs composite was prepared with TMCNFs, and its morphological analysis verified the good dispersion of TMCNFs in the PHA. The tensile strength of the composite was enhanced when 10% TMCNFs were added; however, the viscosity decreased as the TMCNFs acted as a thixotropic agent. Adding TMCNFs to PHA enhanced the flowability and infiltration ability of the PHA–TMCNFs-based adhesive, and an increase in the loss tangent (Tan δ) and adjustment of viscosity without reducing the adhesive strength was also observed. These changes in properties can improve the flowability and dispersibility of the PHA–TMCNFs adhesive on a rough adhesive surface at low stress. Thus, it is expected that double-silanized CNFs effectively improve their interfacial adhesion in PHA and the adhesive properties of the PHA–CNFs composites, which can be utilized for more suitable adhesive applications.