High Performance of Titanium Dioxide Reinforced Acrylonitrile Butadiene Rubber Composites

Recently, dielectric elastomer actuators (DEA) have emerged as one of the most promising materials for use in soft robots. However, DEA needs a high operating voltage and high mechanical properties. By increasing the dielectric constant of elastomeric materials, it is possible to decrease the operating voltage required. Thus, elastomeric composites with a high dielectric constant and strong mechanical properties are of interest. The aim of this research was to investigate the effect of titanium dioxide (TiO(2)) content ranging from 0 to 110 phr on the cure characteristics, and physical, dielectric, dynamic mechanical, and morphological properties of acrylonitrile butadiene rubber (NBR) composites. The addition of TiO(2) reduced the scorch time (t(s)(1)) as well as the optimum cure time (t(c90)) but increased the cure rate index (CRI), minimum torque (M(L)), maximum torque (M(H)), and delta torque (M(H) − M(L)). The optimal TiO(2) content for maximum tensile strength and elongation at break was 90 phr. Tensile strength and elongation at break were increased by 144.8% and 40.1%, respectively, over pure NBR. A significant mechanical property improvement was observed for TiO(2)-filled composites due to the good dispersion of TiO(2) in the NBR matrix, which was confirmed by scanning electron microscopy (SEM). Moreover, incorporating TiO(2) filler gave a higher storage modulus, a shift in glass transition temperature (T(g)) to a higher temperature, and reduced damping in dynamic mechanical thermal analysis (DMTA). The addition of TiO(2) to NBR rubber increased the dielectric constant of the resultant composites in the tested frequency range from 10(2) to 10(5) Hz. As a result, TiO(2)-filled NBR composite has a high potential for dielectric elastomer actuator applications.