Curing Kinetics of Bioderived Furan-Based Epoxy Resins: Study on the Effect of the Epoxy Monomer/Hardener Ratio

The potential of furan-based epoxy thermosets as a greener alternative to diglycidyl ether of Bisphenol A (DGEBA)-based resins has been demonstrated in recent literature. Therefore, a deep investigation of the curing behaviour of these systems may allow their use for industrial applications. In this work, the curing mechanism of 2,5-bis[(oxiran-2-ylmethoxy)methyl]furan (BOMF) with methyl nadic anhydride (MNA) in the presence of 2-methylimidazole as a catalyst is analyzed. In particular, three systems characterized by different epoxy/anhydride molar ratios are investigated. The curing kinetics are studied through differential scanning calorimetry, both in isothermal and non-isothermal modes. The total heat of reaction of the epoxy resin as well as its activation energy are estimated by the non-isothermal measurements, while the fitting of isothermal data with Kamal’s autocatalytic model provides the kinetic parameters. The results are discussed as a function of the resin composition. The global activation energy for the curing process of BOMF/MNA resins is in the range 72–79 kJ/mol, depending on both the model used and the sample composition; higher values are experienced by the system with balanced stoichiometry. By the fitting of the isothermal analysis, it emerged that the order of reaction is not only dependent on the temperature, but also on the composition, even though the values range between 0.31 and 1.24.