Analysis of Different Organic Rankine and Kalina Cycles for Waste Heat Recovery in the Iron and Steel Industry

[Image: see text] This study analyzed waste heat of two sections including the rolling section and electric arc furnace with low and medium temperature ranges, respectively. Organic Rankine cycles (ORCs) and Kalina cycles are the best technologies for the conversion of low-quality and medium-quality thermal energy to electrical power. The ORC applies the principle of the steam Rankine cycle, but it uses organic working fluids with low boiling points to recover heat from lower temperature heat sources. Also, in the Kalina cycle, ammonia water is selected as the working fluid because of its variable boiling point and thermodynamic properties. This study employs the thermo-economic method using the genetic algorithm to optimize the performance of three different ORC systems including a basic ORC (BORC) system, a single-stage regenerative ORC (SRORC) system, and a double-stage regenerative ORC (DRORC) system using five different working fluids and a basic Kalina cycle with KCS34 and complex cycle under the same waste heat conditions. Based on the energy and exergy analysis, the complex Kalina cycle shows the best performance among all studied cycles. The next best performance was exhibited by KCS34 and DROC, respectively. In general, Kalina cycles and ORCs are suitable for low-temperature and medium-temperature heat sources, respectively. According to the thermo-economic analysis, KCS34 in the rolling section and DRORC in EAF show optimum performance for heat recovery. R11 and R113 are selected as the best working fluids for ORCs, and ammonia with a concentration of 0.9 in the mixture is the optimal solution for Kalina cycles.