Cargando…

The Effect of Hypochlorous Acid Disinfectant on the Reproduction of Details and Surface Hardness of Type III Dental Stone

Introduction Gypsum products have been used for many years in dentistry. They are used to make casts that are used in different dental laboratory procedures. It is considered a source of contamination because it comes in contact with blood and saliva that are found on dental impressions. Because it...

Descripción completa

Detalles Bibliográficos
Autores principales: Jasim, Zaid M, Abass, Shorouq M
Formato: Online Artículo Texto
Lenguaje:English
Publicado: Cureus 2022
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9800944/
https://www.ncbi.nlm.nih.gov/pubmed/36600860
http://dx.doi.org/10.7759/cureus.32061
Descripción
Sumario:Introduction Gypsum products have been used for many years in dentistry. They are used to make casts that are used in different dental laboratory procedures. It is considered a source of contamination because it comes in contact with blood and saliva that are found on dental impressions. Because it is difficult to make sure that every impression brought to the dental laboratory has been cleaned and because cleaning impressions is a complicated process that can lead to problems because of the way impression materials are made, cleaning the cast has become a key part of preventing infections. For this study, we used two ways (immersion and spray) to apply a hypochlorous acid (HOCl) disinfectant solution to type III dental stone to see how they affected the stone's surface hardness and its ability to show surface details accurately. Materials and methods A total of 100 samples of type III dental stone, 50 samples for each test, which include the reproduction of detail test and surface hardness test, were prepared and randomly divided into five groups, 10 samples for each test group, which include group A (control), group B (immersion in 200 ppm HOCl disinfectant for five minutes), group C (spraying with 200 ppm HOCl disinfectant for five minutes), group D (immersion in 0.6% sodium hypochlorite (NaOCl) disinfectant for five minutes), and group E (spraying with 0.6% NaOCl disinfectant for five minutes). Results The results showed that all the samples had met the reproduction of detail test requirement after disinfection with HOCl, while a significant reduction in the surface hardness of type III stone samples was also shown. Conclusion The less undesirable effects of HOCl disinfectant solution on the surface hardness of type III dental stone when compared to sodium hypochlorite, as well as the absence of adverse effects on detail reproduction, made the HOCl disinfectant solution a good choice for dentists and dental laboratory personnel for cast disinfection and contamination control.