Investigation of the Technological Possibility of Manufacturing Volumetric Shaped Ductile Cast Iron Products in Open Dies

Information about the technological possibility of stamping in open dies, round-shaped forgings made of ductile cast iron, is outlined herein. Cast iron’s propensity for plastic deformation under complex loading conditions is analyzed from the standpoint of the morphology of graphite inclusions, depending on the degree and mechanical scheme of deformation. The research methodology included: the choice of a brand of cast iron with spherical graphite and the technological process of its deformation; mathematical modeling of the deformation process using the DEFORM–3D software package; stamping of an experimental batch of forgings; and microstructural studies of the forging material, together with the data of its stress–strain state and the direction of flow of the material. Under the conditions of comprehensive compression of the workpiece material at the beginning of the deformation process, lateral pressure was created from the tool walls. It was carried out by selecting the size and shape of the initial blank by mathematical modeling. When analyzing the morphology of graphite inclusions, the stress state scheme was determined as the main influencing factor. The greatest change in the shape and size of graphite inclusions of cast iron, including their crushing, corresponds to the condition of the disappearance of all-round compression. When stamping in open dies, this occurs in the area where the material exits from the stamp engraving into the flash gutter. In the process of forming, cast iron showed the possibility of deformation in the deformation intensity index ε(i) = 2.5.