Cargando…

Microstructure Evolution, Constitutive Modelling, and Superplastic Forming of Experimental 6XXX-Type Alloys Processed with Different Thermomechanical Treatments

This study focused on the microstructural analysis, superplasticity, modeling of superplastic deformation behavior, and superplastic forming tests of the Al-Mg-Si-Cu-based alloy modified with Fe, Ni, Sc, and Zr. The effect of the thermomechanical treatment with various proportions of hot/cold rollin...

Descripción completa

Detalles Bibliográficos
Autores principales:	Mochugovskiy, Andrey G., Mosleh, Ahmed O., Kotov, Anton D., Khokhlov, Andrey V., Kaplanskaya, Ludmila Yu., Mikhaylovskaya, Anastasia V.
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9821823/ https://www.ncbi.nlm.nih.gov/pubmed/36614782 http://dx.doi.org/10.3390/ma16010445

Ejemplares similares

Superplasticity of Ti-6Al-4V Titanium Alloy: Microstructure Evolution and Constitutive Modelling
por: Mosleh, Ahmed O., et al.
Publicado: (2019)

A High-Strain-Rate Superplasticity of the Al-Mg-Si-Zr-Sc Alloy with Ni Addition
por: Mochugovskiy, Andrey, et al.
Publicado: (2021)

Effect of Boron on the Microstructure, Superplastic Behavior, and Mechanical Properties of Ti-4Al-3Mo-1V Alloy
por: Postnikova, Maria N., et al.
Publicado: (2023)

High Strain Rate Superplasticity in Al-Zn-Mg-Based Alloy: Microstructural Design, Deformation Behavior, and Modeling
por: Yakovtseva, Olga, et al.
Publicado: (2020)

Superplastic Behavior and Microstructural Features of the VT6 Titanium Alloy with an Ultrafine-Grained Structure during Upsetting
por: Dyakonov, Grigory S., et al.
Publicado: (2023)

Superplasticity of alloys, intermetallides and ceramics
por: Kaibyshev, Oscar A
Publicado: (1992)

Effect of Multidirectional Forging on the Grain Structure and Mechanical Properties of the Al–Mg–Mn Alloy
por: Kishchik, Mikhail S., et al.
Publicado: (2018)

Microstructure and Texture Evolution during Superplastic Deformation of SP700 Titanium Alloy
por: Tian, Ning, et al.
Publicado: (2022)

The Microstructure and Strength of UFG 6060 Alloy after Superplastic Deformation at a Lower Homologous Temperature
por: Bobruk, Elena V., et al.
Publicado: (2022)

Cavitation During Superplastic Forming
por: Campbell, John
Publicado: (2011)

Room-Temperature Superplasticity in an Ultrafine-Grained Magnesium Alloy
por: Edalati, Kaveh, et al.
Publicado: (2017)

Effect of Sc on the Hot Cracking Properties of 7xxx Aluminum Alloy and the Microstructure of Squeeze Castings
por: Xu, Yongtao, et al.
Publicado: (2021)

On the Competition between Intergranular and Transgranular Failure within 7xxx Al Alloys with Tailored Microstructures
por: Han, Sutao, et al.
Publicado: (2023)

Microstructure Evolution in a 6082 Aluminium Alloy during Thermomechanical Treatment
por: Poletti, Cecilia, et al.
Publicado: (2018)

Boronization and Carburization of Superplastic Stainless Steel and Titanium-Based Alloys
por: Matsushita, Masafumi
Publicado: (2011)

Low-Temperature Superplasticity and High Strength in the Al 2024 Alloy with Ultrafine Grains
por: Bobruk, Elena V., et al.
Publicado: (2023)

Design and optimization of vertex detector foils by superplastic forming
por: Snippe, Quirin Hendrik Catherin
Publicado: (2011)

Influence of Fe and Mn on the Microstructure Formation in 5xxx Alloys—Part II: Evolution of Grain Size and Texture
por: Grasserbauer, Jakob, et al.
Publicado: (2021)

Influence of Fe and Mn on the Microstructure Formation in 5xxx Alloys—Part I: Evolution of Primary and Secondary Phases
por: Grasserbauer, Jakob, et al.
Publicado: (2021)

Effect of the Equal Channel Angular Pressing on the Microstructure and Phase Composition of a 7xxx Series Al-Zn-Mg-Zr Alloy
por: Ahmed, Anwar Qasim, et al.
Publicado: (2023)

Correlation among Composition, Microstructure and Hardness of 7xxx Aluminum Alloy Using Original Statistical Spatial-Mapping Method
por: Han, Bing, et al.
Publicado: (2022)

Bearing Aluminum-Based Alloys: Microstructure, Mechanical Characterizations, and Experiment-Based Modeling Approach
por: Mosleh, Ahmed O., et al.
Publicado: (2022)

Superplasticity in an organic crystal
por: Takamizawa, Satoshi, et al.
Publicado: (2018)

Effect of Cold Drawing and Annealing in Thermomechanical Treatment Route on the Microstructure and Functional Properties of Superelastic Ti-Zr-Nb Alloy
por: Kudryashova, Anastasia, et al.
Publicado: (2023)

Evaluation of the Microstructure and Mechanical Properties of a New Modified Cast and Laser-Melted AA7075 Alloy
por: Khalil, Asmaa M., et al.
Publicado: (2019)

Superplastic Deformation Mechanisms in Fine-Grained 2050 Al-Cu-Li Alloys
por: Li, Hongping, et al.
Publicado: (2020)

Ultrahigh high-strain-rate superplasticity in a nanostructured high-entropy alloy
por: Nguyen, Nhung Thi-Cam, et al.
Publicado: (2020)

High-Throughput Computing Assisted by Knowledge Graph to Study the Correlation between Microstructure and Mechanical Properties of 6XXX Aluminum Alloy
por: Zheng, Xiaoyu, et al.
Publicado: (2022)

Microstructure Evolution and Localized Corrosion Susceptibility of an Al-Zn-Mg-Cu-Zr 7xxx Alloy with Minor Cr Addition
por: Akuata, Chijioke Kenneth, et al.
Publicado: (2023)

Polonia XXX
Publicado: (1974)

Review on Micro-Alloying and Preparation Method of 7xxx Series Aluminum Alloys: Progresses and Prospects
por: Dai, Yuxin, et al.
Publicado: (2022)

Effect of Ni/Si Mass Ratio and Thermomechanical Treatment on the Microstructure and Properties of Cu-Ni-Si Alloys
por: Li, Jiang, et al.
Publicado: (2019)

Effect of Thermomechanical Treatments on the Phases, Microstructure, Microhardness and Young’s Modulus of Ti-25Ta-Zr Alloys
por: Kuroda, Pedro Akira Bazaglia, et al.
Publicado: (2019)

Low-Temperature Superplasticity and Deformation Mechanism of Ti-6Al-4V Alloy
por: Zhou, Ge, et al.
Publicado: (2018)

Transition from poor ductility to room-temperature superplasticity in a nanostructured aluminum alloy
por: Edalati, Kaveh, et al.
Publicado: (2018)

Superplastic Deformation Mechanisms of Superfine/Nanocrystalline Duplex PM-TiAl-Based Alloy
por: Gong, Xuebo, et al.
Publicado: (2017)

Efficient Coarse‐Grained Superplasticity of a Gigapascal Lightweight Refractory Medium Entropy Alloy
por: Jia, Yuefei, et al.
Publicado: (2023)

Micrograin Superplasticity: Characteristics and Utilization
por: Mohamed, Farghalli A.
Publicado: (2011)

Superplastic Deformation of Al–Cu Alloys after Grain Refinement by Extrusion Combined with Reversible Torsion
por: Rodak, Kinga, et al.
Publicado: (2020)

Effect of Zr Addition on the Mechanical Properties and Superplasticity of a Forged SP700 Titanium Alloy
por: Han, Dong, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_f4glqbcpvtskh21e0gl2hv2sno