Cargando…

Blue Laser for Polymerization of Bulk-Fill Composites: Influence on Polymerization Kinetics

The objective of this study was to compare the polymerization kinetics of bulk-fill resin composites cured with a LED-curing device and a diode laser (449 nm). Three bulk-fill composites were light-cured with constant radiation exposure at 10 J/cm(2) by varying radiant exitance and curing time. The...

Descripción completa

Detalles Bibliográficos
Autores principales:	Negovetic Mandic, Visnja, Par, Matej, Marovic, Danijela, Rakić, Mario, Tarle, Zrinka, Klarić Sever, Eva
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9864537/ https://www.ncbi.nlm.nih.gov/pubmed/36678057 http://dx.doi.org/10.3390/nano13020303

Ejemplares similares

Effect of Rapid Polymerization on Water Sorption and Solubility of Bulk-fill Composites
por: Klarić, Nikolina, et al.
Publicado: (2022)

Rapid 3 s Curing: What Happens in Deep Layers of New Bulk-Fill Composites?
por: Marovic, Danijela, et al.
Publicado: (2021)

Effect of polymerization mode on shrinkage kinetics and degree of conversion of dual-curing bulk-fill resin composites
por: Burrer, Phoebe, et al.
Publicado: (2023)

Aging-Dependent Changes in Mechanical Properties of the New Generation of Bulk-Fill Composites
por: Marovic, Danijela, et al.
Publicado: (2022)

Polymerization Kinetics and Development of Polymerization Shrinkage Stress in Rapid High-Intensity Light-Curing
por: Par, Matej, et al.
Publicado: (2022)

The effect of rapid high-intensity light-curing on micromechanical properties of bulk-fill and conventional resin composites
por: Par, Matej, et al.
Publicado: (2020)

Incorporation of Copper-Doped Mesoporous Bioactive Glass Nanospheres in Experimental Dental Composites: Chemical and Mechanical Characterization
por: Marovic, Danijela, et al.
Publicado: (2021)

Proposition of New Testing Procedure for the Mechanical Properties of Bulk-Fill Materials
por: Macan, Matea, et al.
Publicado: (2023)

Impact of Copper-Doped Mesoporous Bioactive Glass Nanospheres on the Polymerisation Kinetics and Shrinkage Stress of Dental Resin Composites
por: Marovic, Danijela, et al.
Publicado: (2022)

Polymerization kinetics of experimental resin composites functionalized with conventional (45S5) and a customized low-sodium fluoride-containing bioactive glass
por: Par, Matej, et al.
Publicado: (2021)

Polymerization shrinkage behaviour of resin composites functionalized with unsilanized bioactive glass fillers
por: Par, Matej, et al.
Publicado: (2020)

Post-Cure Development of the Degree of Conversion and Mechanical Properties of Dual-Curing Resin Cements
por: Carek, Andreja, et al.
Publicado: (2022)

Bulk Fill Composites Have Similar Performance to Conventional Dental Composites
por: Haugen, Håvard J., et al.
Publicado: (2020)

Toxicology of Pre-heated Composites Polymerized Directly and Through CAD/CAM Overlay
por: Knezevic, Alena, et al.
Publicado: (2018)

Improved Flexural Properties of Experimental Resin Composites Functionalized with a Customized Low-Sodium Bioactive Glass
por: Par, Matej, et al.
Publicado: (2022)

Remineralizing amorphous calcium phosphate based composite resins: the influence of inert fillers on monomer conversion, polymerization shrinkage, and microhardness
por: Marović, Danijela, et al.
Publicado: (2016)

Water-Induced Changes in Experimental Resin Composites Functionalized with Conventional (45S5) and Customized Bioactive Glass
por: Muradbegovic, Alen, et al.
Publicado: (2023)

Polymerization shrinkage and shrinkage stress of bulk-fill and non-bulk-fill resin-based composites
por: Yu, Peng, et al.
Publicado: (2022)

Long-Term Assessment of Contemporary Ion-Releasing Restorative Dental Materials
por: Marovic, Danijela, et al.
Publicado: (2022)

Effect of Conventional Adhesive Application or Co-Curing Technique on Dentin Bond Strength
por: Vukelja, Josipa, et al.
Publicado: (2021)

The polymerization efficiency of a bulk-fill composite based on matrix-modification technology
por: Elshazly, Tarek M., et al.
Publicado: (2020)

Degree of Conversion and Polymerization Shrinkage of Low Shrinkage Bulk-Fill Resin Composites
por: Salem, Haidy N., et al.
Publicado: (2019)

Light Transmittance and Polymerization of Bulk-Fill Composite Materials Doped with Bioactive Micro-Fillers
por: Dieckmann, Phoebe, et al.
Publicado: (2019)

Polymerization Shrinkage of Five Bulk-Fill Composite Resins in Comparison with a Conventional Composite Resin
por: Abbasi, Mahdi, et al.
Publicado: (2018)

A comparison of dentin bond strength and degree of polymerization of bulk-fill and methacrylate-based flowable composites
por: Karatas, Ozcan, et al.
Publicado: (2018)

Evaluation of Efficiency of Polymerization, Surface Roughness, Porosity and Adaptation of Flowable and Sculptable Bulk Fill Composite Resins
por: Gjorgievska, Elizabeta, et al.
Publicado: (2021)

Comparison of polymerization shrinkage of a new bulk‐fill flowable composite with other composites: An in vitro study
por: Khoramian Tusi, Somayeh, et al.
Publicado: (2022)

A New Customized Bioactive Glass Filler to Functionalize Resin Composites: Acid-Neutralizing Capability, Degree of Conversion, and Apatite Precipitation
por: Par, Matej, et al.
Publicado: (2020)

Experimental Bioactive Glass-Containing Composites and Commercial Restorative Materials: Anti-Demineralizing Protection of Dentin
por: Par, Matej, et al.
Publicado: (2021)

Mechanism and kinetics of addition polymerizations
por: Kucera, M
Publicado: (1991)

Cuspal Displacement Induced by Bulk Fill Resin Composite Polymerization: Biomechanical Evaluation Using Fiber Bragg Grating Sensors
por: Vinagre, Alexandra, et al.
Publicado: (2016)

The Effect of Irradiance on the Degree of Conversion and Volumetric Polymerization Shrinkage of Different Bulk-Fill Resin-Based Composites: An In Vitro Study
por: Bin Nooh, Abrar N., et al.
Publicado: (2021)

Degree of conversion of experimental resin composites containing bioactive glass 45S5: the effect of post-cure heating
por: Par, Matej, et al.
Publicado: (2019)

Fluoride-Releasing Restorative Materials: The Effect of a Resinous Coat on Ion Release
por: Kelić, Katarina, et al.
Publicado: (2020)

Anti-demineralizing protective effects on enamel identified in experimental and commercial restorative materials with functional fillers
por: Par, Matej, et al.
Publicado: (2021)

Effect of adhesive coating on calcium, phosphate, and fluoride release from experimental and commercial remineralizing dental restorative materials
por: Par, Matej, et al.
Publicado: (2022)

Effect of Graphene Oxide on the Reaction Kinetics of Methyl Methacrylate In Situ Radical Polymerization via the Bulk or Solution Technique
por: Tsagkalias, Ioannis S., et al.
Publicado: (2017)

Growth kinetics of plasma-polymerized films
por: Hwang, Sukyoung, et al.
Publicado: (2015)

Drug release behavior of polymeric matrix filled in capsule
por: Phaechamud, Thawatchai, et al.
Publicado: (2016)

Using Copper-Doped Mesoporous Bioactive Glass Nanospheres to Impart Anti-Bacterial Properties to Dental Composites
por: Munir, Arooj, et al.
Publicado: (2022)

Cannot write session to /tmp/vufind_sessions/sess_i7q1ksa0h02o23quk63qc6s283