A quality-by-design eco-friendly UV-HPLC method for the determination of four drugs used to treat symptoms of common cold and COVID-19

An optimization approach based on full factorial design was employed for developing an HPLC–UV method for simultaneous determination of a quaternary mixture used for the treatment of symptoms related to common cold and COVID-19. The quaternary mixture is composed of paracetamol, levocetirizine dihydrochloride, phenylephrine hydrochloride and ambroxol hydrochloride. The developed technique is a green, fast and simple method that uses isocratic elution of mobile phase consisting of 20:5:75 (v/v) of ethanol: acetonitrile: 2.5 mM heptane-1-sulphonic acid sodium salt at pH 6.5 [Formula: see text] 0.02. The chromatographic separation was carried out using Hypersil BDS Cyano LC Column (250 × 4.6 mm, 5 μm) with 230 nm UV detection and 1.0 mL/min. flow rate. Avoiding the routine methodology and resorting to the modern technology—represented in the usage of experimental design—allows rapid determination of the four drugs using the optimum quantity of chemicals to avoid any waste of resources. The quaternary mixture was eluted in less than 9 min., where retention times of paracetamol, levocetirizine dihydrochloride, phenylephrine hydrochloride and ambroxol hydrochloride were found to be 2.2, 3.8, 6.6 and 8.8 min., respectively. The calibration graphs of the four drugs were linear over concentration ranges of 50.0–500.0, 0.5–20.0, 0.5–20.0 and 0.5–100.0 µg/mL for paracetamol, levocetirizine dihydrochloride, phenylephrine hydrochloride and ambroxol hydrochloride, respectively with correlation coefficients higher than 0.999. The method is accurate with mean recoveries between 99.87 and 100.04%, precise, as %RSD for the intraday and interday precision were between 0.61 and 1.64% and very sensitive with limit of detections (LOD)’s between 29 and 147 ng/mL and limit of quantification (LOQ)’s between 95 and 485 ng/mL. The proposed method was successfully applied for the analysis of the four drugs either in raw materials or in prepared tablet with the least amount of chemicals within short time. It is also validated following International Conference on Harmonization Guidelines. The proposed method was found to be green according to the most common greenness assessment tools; NEMI, GAPI, Analytical Eco-Scale and AGREE methods. The advantages of the proposed method qualify it for routine analysis of the studied drugs either in single or co-formulated dosage form in quality control labs.