Fabrication of dialysis membrane from cotton Giza 86 cellulose di-acetate prepared using Ac(2)O and NiCl(2) as a new catalyst

This attempt has been made to synthesize the cellulose di-acetate in a solvent-free acetylation system of cotton Giza 86 cellulose with Ac(2)O (200 and 300 ml) in the presence of NiCl(2)(.)6HO (1.0, 1.5 and 2.0 g) as an effectively available and new catalyst by the conventional reflux and microwave irradiation methods. This study also illustrates the preparation of a dialysis membrane made from a cellulose di-acetate–dichloromethane-methanol-polyethylene glycol (MW: 200) casting solution. The microwave irradiation method for the synthesis of cellulose di-acetate showed excellent yields and short reaction time, which is an important feature of this method. The impact of the two methods on the cellulose di-acetate formation and its used in the dialysis membrane formulations was studied. The experimental degree of substitution of the prepared cellulose di-acetate values (DS = 2.00–2.7) showed an agreement with the calculated values by FTIR and (1)H-NMR analysis methods. The formation of cellulose di-acetate with percentage yields varied from 62.85 to 89.85%. The applicability of the prepared membrane in dialysis operation was evaluated in terms of urea clearance, rejection of Bovine Serum Albumin (BSA) and flux of pure water. Characterization of cellulose di-acetate was achieved through (1)H-NMR, FTIR, TGA, and BET analyses. The CA-PEG blend membrane was examined by contact angle measurement, porosity, and water uptake of the membrane. The cellulose acetate membrane surface morphology was determined using SEM. It is observable that the fabricated CA-PEG blend membrane from synthesized cellulose di-acetate by using Nickel chloride as a catalyst is showing remarkable rejection of BSA and urea clearance up to 100 and 67.2%, respectively. The present work is promising and applicable in dialysis membranes.