Cargando…

Hard Wear-Resistant Ti-Si-C Coatings for Cu-Cr Electrical Contacts

In this study, hard wear-resistant Ti-Si-C coatings were deposited on Cu-Cr materials to improve their performance as sliding electrical contact materials. A ceramic disk composed of Ti(3)SiC(2) and TiC phases was used as a target for DC magnetron sputtering to deposit the coatings. The influence of...

Descripción completa

Detalles Bibliográficos
Autores principales:	Kiryukhantsev-Korneev, Ph., Sytchenko, A., Moskovskikh, D., Kuskov, K., Volkova, L., Poliakov, M., Pogozhev, Y., Yudin, S., Yakushko, E., Nepapushev, A.
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9917946/ https://www.ncbi.nlm.nih.gov/pubmed/36769943 http://dx.doi.org/10.3390/ma16030936

Ejemplares similares

Structure and Properties of Zr-Mo-Si-B-(N) Hard Coatings Obtained by d.c. Magnetron Sputtering of ZrB(2)-MoSi(2) Target
por: Kiryukhantsev-Korneev, Philipp, et al.
Publicado: (2021)

Two-Layer Nanocomposite TiC-Based Coatings Produced by a Combination of Pulsed Cathodic Arc Evaporation and Vacuum Electro-Spark Alloying
por: Kiryukhantsev-Korneev, Philipp, et al.
Publicado: (2020)

Amorphous/Nanocrystalline High-Entropy CoCrFeNiTi(x) Thin Films with Low Thermal Coefficient of Resistivity Obtained via Magnetron Deposition
por: Poliakov, Maksim, et al.
Publicado: (2023)

Manufacturing of Conductive, Wear-Resistant Nanoreinforced Cu-Ti Alloys Using Partially Oxidized Electrolytic Copper Powder
por: Vorotilo, Stepan, et al.
Publicado: (2020)

Effects of Nb Additions and Heat Treatments on the Microstructure, Hardness and Wear Resistance of CuNiCrSiCoTiNb(x) High-Entropy Alloys
por: Avila-Salgado, Denis Ariel, et al.
Publicado: (2022)

Extremely hard and tough high entropy nitride ceramics
por: Moskovskikh, Dmitry, et al.
Publicado: (2020)

Microstructure and Wear Resistance of Laser-Clad Ni–Cu–Mo–W–Si Coatings on a Cu–Cr–Zr Alloy
por: Zhao, Xiaojun, et al.
Publicado: (2022)

Development of in-Situ Al-Si/CuAl(2) Metal Matrix Composites: Microstructure, Hardness, and Wear Behavior
por: Tash, Mahmoud M., et al.
Publicado: (2016)

Impact Abrasive Wear Property of CrAlN/TiSiN Multilayer Coating at Elevated Temperatures
por: Luo, Ying, et al.
Publicado: (2022)

Combustion Synthesis and Reactive Spark Plasma Sintering of Non-Equiatomic CoAl-Based High Entropy Intermetallics
por: Kuskov, Kirill Vasilevich, et al.
Publicado: (2023)

Preparation and Characterization of In Situ (TiC-TiB(2))/Al-Cu-Mg-Si Composites with High Strength and Wear Resistance
por: Gao, Yu-Yang, et al.
Publicado: (2022)

Effects of Cr and Zr Addition on Microstructures, Compressive Properties, and Abrasive Wear Behaviors of In Situ TiB(2)/Cu Cermets
por: Qiu, Feng, et al.
Publicado: (2018)

Data related to optimized process parameters influence on hardness, microstructural evolution and wear resistance performance of Al-Si-Sn-Cu/Ti-6Al-4V composite coatings
por: Fatoba, O.S., et al.
Publicado: (2019)

Diffusion Barrier Performance of AlCrTaTiZr/AlCrTaTiZr-N High-Entropy Alloy Films for Cu/Si Connect System
por: Jiang, Chunxia, et al.
Publicado: (2020)

On The Microstructures and Hardness of The Nb-24Ti-18Si-5Al-5Cr-5Ge and Nb-24Ti-18Si-5Al-5Cr-5Ge-5Hf (at.%) Silicide Based Alloys
por: Li, Zifu, et al.
Publicado: (2019)

Damage Accumulation Phenomena in Multilayer (TiAlCrSiY)N/(TiAlCr)N, Monolayer (TiAlCrSiY)N Coatings and Silicon upon Deformation by Cyclic Nanoindentation
por: Kovalev, Anatoly I., et al.
Publicado: (2022)

Sliding Wear Performance of AlCrN Coating on TiB(2)/Ti Composites at High Temperatures
por: Michalczewski, Remigiusz, et al.
Publicado: (2021)

Electrical and Heat Distributions and Their Influence on the Mass Transfer during the Flash Spark Plasma Sintering of a Cu/Cr Nanocomposite: Experiments and Numerical Simulation
por: Abedi, Mohammad, et al.
Publicado: (2022)

Effect of AISI H13 Steel Substrate Nitriding on AlCrN, ZrN, TiSiN, and TiCrN Multilayer PVD Coatings Wear and Friction Behaviors at a Different Temperature Level
por: Özkan, Doğuş, et al.
Publicado: (2023)

Quantifying Cutting and Wearing Behaviors of TiN- and CrN-Coated AISI 1070 Steel
por: Cakan, Ahmet, et al.
Publicado: (2008)

Improvement of Corrosion and Wear Resistance of CoCrNiSi(0.3) Medium-Entropy Alloy by Sputtering CrN Film
por: Chang, Yi-Chun, et al.
Publicado: (2023)

The Effect of Cu Addition on the Precipitation Sequence in the Al-Si-Mg-Cr Alloy
por: Chen, Bin, et al.
Publicado: (2022)

Structure and Wear Resistance of TiC-Reinforced Al(1.8)CrCuFeNi(2) High-Entropy Alloy Coating Using Laser Cladding
por: Guo, Jing, et al.
Publicado: (2023)

Investigation of Microstructure and Wear Properties of Precipitates-Strengthened Cu-Ni-Si-Fe Alloy
por: Peng, Chun-Hao, et al.
Publicado: (2023)

Fabrication of Biomedical Ti-Zr-Nb by Reducing Metal Oxides with Calcium Hydride
por: Yudin, Sergey, et al.
Publicado: (2023)

Wear-Resistant TiC Strengthening CoCrNi-Based High-Entropy Alloy Composite
por: Cai, Yanlin, et al.
Publicado: (2021)

TiCrN-TiAlN-TiAlSiN-TiAlSiCN multi-layers utilized to increase tillage tools useful lifetime
por: Sharifi Malvajerdi, Shahab, et al.
Publicado: (2019)

Friction and Wear Properties of Ni(3)Si Alloy with Ti Addition at High Temperatures
por: Wu, Changyin, et al.
Publicado: (2020)

Effect of Cr, Mo and Al on Microstructure, Abrasive Wear and Corrosion Resistance of Ni-Mn-Cu Cast Iron
por: Medyński, Daniel, et al.
Publicado: (2019)

The Influence of Severe Plastic Deformation and Subsequent Annealing on the Microstructure and Hardness of a Cu–Cr–Zr Alloy
por: Kapoor, Garima, et al.
Publicado: (2020)

CO oxidation and organic dyes degradation over graphene–Cu and graphene–CuNi catalysts obtained by solution combustion synthesis
por: Khort, Alexander, et al.
Publicado: (2020)

Effect of Metallic Coatings on the Wear Performance and Mechanism of 30CrMnSiNi2A Steel
por: Zu, Huicheng, et al.
Publicado: (2023)

Improvement of Tribological Performance of TiAlNbN Hard Coatings by Adding AlCrN
por: Chang, Yin-Yu, et al.
Publicado: (2022)

Assessing the potential biological activities of TiO(2) and Cu, Ni and Cr doped TiO(2) nanoparticles
por: Munir, Shamsa, et al.
Publicado: (2022)

Effect of Microstructure and Hardness on Cavitation Erosion and Dry Sliding Wear of HVOF Deposited CoNiCrAlY, NiCoCrAlY and NiCrMoNbTa Coatings
por: Szala, Mirosław, et al.
Publicado: (2021)

The Wear Behavior of the Laser Cladded Ti-Al-Si Composite Coatings on Ti-6Al-4V Alloy with Additional TiC
por: Liu, Ran, et al.
Publicado: (2021)

Thermo-Mechanical Treatment for Reducing the Wear Rate of CuCrZr Tool Electrodes during Electro-Discharge Machining
por: Skiba, Jacek, et al.
Publicado: (2023)

Contact Behavior of Composite CrTiSiN Coated Dies in Compressing of Mg Alloy Sheets under High Pressure
por: Yang, T.S., et al.
Publicado: (2018)

Improvement in Hardness and Wear Behaviour of Iron-Based Mn–Cu–Sn Matrix for Sintered Diamond Tools by Dispersion Strengthening
por: Cygan-Bączek, Elżbieta, et al.
Publicado: (2021)

Study on Hardness, Microstructure, Distribution of the Self-lubricating Phase, Friction and Wear Property of 1Cr13MoS after Heat Treatment
por: Li, Shaolong, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_es0ln3i15u8fu0o6rc2qc9dtqr