Estimation of rocks’ failure parameters from drilling data by using artificial neural network

Comprehensive and precise knowledge about rocks' mechanical properties facilitate the drilling performance optimization, and hydraulic fracturing design and reduces the risk of wellbore-related problems. This paper is concerned with the failure parameters, namely, cohesion and friction angle which are conventionally estimated using Mohr's cycles that are drawn using compressional tests on rock samples. The availability, continuity and representability, and cost of acquiring those samples are major concerns. The objective of this paper is to investigate an alternative technique to estimate these parameters from the drilling data. In this work, more than 2200 data points were used to develop and test the correlations built by the artificial neural network. Each data point comprises the failure parameters and five drilling records that are available instantaneously in drilling rigs such as rate of penetration, weight on bit, and torque. The data were grouped into three datasets, training, testing, and validation with a corresponding percentage of 60/20/20, the former two sets were utilized in the models' building while the last one was hidden as a final check afterward. The models were optimized and evaluated using the correlation coefficient (R) and average absolute percentage error (AAPE). In general, the two models yielded good fits with the actual values. The friction angle model yielded R values around 0.86 and AAPE values around 4% for the three datasets. While the model for cohesion resulted in R values around 0.89 and APPE values around 6%. The equation and the parameters of those models are reported in the paper. These results show the ability of in-situ and instantaneous rock mechanical properties estimation with good reliability and at no additional costs.