Cargando…

Fabrication and Assembly Techniques for Sub-mm Battery-Free Epicortical Implants

Over the past three decades, we have seen significant advances in the field of wireless implantable medical devices (IMDs) that can interact with the nervous system. To further improve the stability, safety, and distribution of these interfaces, a new class of implantable devices is being developed:...

Descripción completa

Detalles Bibliográficos
Autores principales:	Khalifa, Adam, Nasrollahpour, Mehdi, Nezaratizadeh, Ali, Sha, Xiao, Stanaćević, Milutin, Sun, Nian X., Cash, Sydney S.
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9966084/ https://www.ncbi.nlm.nih.gov/pubmed/36838175 http://dx.doi.org/10.3390/mi14020476

Ejemplares similares

Circuit-Level Modeling and Simulation of Wireless Sensing and Energy Harvesting With Hybrid Magnetoelectric Antennas for Implantable Neural Devices
por: DAS, DIPTASHREE, et al.
Publicado: (2023)

Secondary motor areas for response inhibition: an epicortical recording and stimulation study
por: Takeyama, Hirofumi, et al.
Publicado: (2022)

Epicortical Brevetoxin Treatment Promotes Neural Repair and Functional Recovery after Ischemic Stroke
por: Sequeira, Erica, et al.
Publicado: (2020)

Graphene active sensor arrays for long-term and wireless mapping of wide frequency band epicortical brain activity
por: Garcia-Cortadella, R., et al.
Publicado: (2021)

Author Correction: Graphene active sensor arrays for long-term and wireless mapping of wide frequency band epicortical brain activity
por: Garcia-Cortadella, R., et al.
Publicado: (2021)

Novel Isoprene Sensor for a Flu Virus Breath Monitor
por: Gouma, Pelagia-Irene, et al.
Publicado: (2017)

Exhaled nitric oxide detection for diagnosis of COVID-19 in critically ill patients
por: Exline, Matthew C., et al.
Publicado: (2021)

Single Exhale Biomarker Breathalyzer
por: Karimi, Yasha, et al.
Publicado: (2019)

A novel wireless recording and stimulating multichannel epicortical grid for supplementing or enhancing the sensory-motor functions in monkey (Macaca fascicularis)
por: Zippo, Antonio G., et al.
Publicado: (2015)

Fabricating sub-nanometer materials through cluster assembly
por: Liu, Qingda, et al.
Publicado: (2022)

Ultra-compact dual-band smart NEMS magnetoelectric antennas for simultaneous wireless energy harvesting and magnetic field sensing
por: Zaeimbashi, Mohsen, et al.
Publicado: (2021)

Investigation of Boron-Doped Graphdiyne as a Promising Anode Material for Sodium-Ion Batteries: A Computational Study
por: Gharehzadeh Shirazi, Sobira, et al.
Publicado: (2020)

Analysis and Design Methodology of RF Energy Harvesting Rectifier Circuit for Ultra-Low Power Applications
por: XU, ZIYUE, et al.
Publicado: (2022)

Additive Manufacturing of Sub-Micron to Sub-mm Metal Structures with Hollow AFM Cantilevers
por: Ercolano, Giorgio, et al.
Publicado: (2019)

Application of a sub–0.1-mm(3) implantable mote for in vivo real-time wireless temperature sensing
por: Shi, Chen, et al.
Publicado: (2021)

A meta-analysis indicating extra-short implants (≤ 6 mm) as an alternative to longer implants (≥ 8 mm) with bone augmentation
por: Yu, Xiaoran, et al.
Publicado: (2021)

Management of sub-5 mm rectal carcinoids with lymph node metastases
por: Toh, James Wei Tatt, et al.
Publicado: (2015)

Retrospective Comparison of Intermediate-term Efficacy of 350 mm(2) Glaucoma Drainage Implants and Medium-sized 230-250 mm(2) Implants
por: Meyer, Alissa M, et al.
Publicado: (2017)

Author Correction: A meta-analysis indicating extra-short implants (≤ 6 mm) as an alternative to longer implants (≥ 8 mm) with bone augmentation
por: Yu, Xiaoran, et al.
Publicado: (2021)

Volume Fabrication of Quantum Cascade Lasers on 200 mm-CMOS pilot line
por: Coutard, J. G, et al.
Publicado: (2020)

Tracking the Migration of Injectable Microdevices in the Rodent Brain Using a 9.4T Magnetic Resonance Imaging Scanner
por: Khalifa, Adam, et al.
Publicado: (2021)

Injectable wireless microdevices: challenges and opportunities
por: Khalifa, Adam, et al.
Publicado: (2021)

Experimental Approach for the Uncertainty Assessment of 3D Complex Geometry Dimensional Measurements Using Computed Tomography at the mm and Sub-mm Scales
por: Jiménez, Roberto, et al.
Publicado: (2017)

Influence of Implant Design (Cylindrical and Conical) in the Load Transfer Surrounding Long (13mm) and Short (7mm) Length Implants: A Photoelastic Analysis
por: Gehrke, Sergio Alexandre, et al.
Publicado: (2016)

The development of microfabricated solenoids with magnetic cores for micromagnetic neural stimulation
por: Khalifa, Adam, et al.
Publicado: (2021)

Cell Encapsulation in Sub-mm Sized Gel Modules Using Replica Molding
por: McGuigan, Alison P., et al.
Publicado: (2008)

Physics with large extra dimensions and nonNewtonian gravity at sub- mm distances
por: Antoniadis, Ignatios
Publicado: (2003)

Neutron transmutation doped (NTD) germanium thermistors for sub-MM bolometer applications
por: Haller, E E, et al.
Publicado: (1996)

In situ observation of localized, sub-mm scale changes of phosphorus biogeochemistry in the rhizosphere
por: Kreuzeder, Andreas, et al.
Publicado: (2018)

Short Dental Implants (≤8.5 mm) versus Standard Dental Implants (≥10 mm): A One-Year Post-Loading Prospective Observational Study
por: Pardo-Zamora, Guillermo, et al.
Publicado: (2021)

Fabrication and electrochemical properties of electrode composites for oxide-type all-solid-state batteries through electrostatic integrated assembly
por: Hikima, Kazuhiro, et al.
Publicado: (2023)

Fabrication and Analysis of 150 mm Aperture Nb$_{3}$Sn LARP MQXF Coils
por: Holik, E F, et al.
Publicado: (2016)

Clinical evaluation of short 6-mm implants alone, short 8-mm implants combined with osteotome sinus floor elevation and standard 10-mm implants combined with osteotome sinus floor elevation in posterior maxillae: study protocol for a randomized controlled trial
por: Shi, Jun-Yu, et al.
Publicado: (2015)

Short implants (<8mm) versus longer implants (≥8mm) with lateral sinus floor augmentation in posterior atrophic maxilla: A meta-analysis of RCT`s in humans
por: Lozano-Carrascal, Naroa, et al.
Publicado: (2020)

Correction: Cell Encapsulation in Sub-mm Sized Gel Modules Using Replica Molding
por: McGuigan, Alison P., et al.
Publicado: (2008)

Potential for sub-mm long erbium-doped composite silicon waveguide DFB lasers
por: Tu, Zhengrui, et al.
Publicado: (2020)

Selection of 1-mm venting or 2.5-mm screw access holes on implant crowns based on cement extrusion and retention capacity
por: Zhou, Huangjun, et al.
Publicado: (2022)

Corneal Optical Quality Following Sub 1.8 mm Micro-Incision Cataract Surgery vs. 2.2 mm Mini-Incision Coaxial Phacoemulsification
por: Alió, Jorge L., et al.
Publicado: (2010)

Fabrication and Microassembly of a mm-Sized Floating Probe for a Distributed Wireless Neural Interface
por: Yeon, Pyungwoo, et al.
Publicado: (2016)

Fabrication of mm-Scale Complementary Split Ring Resonators, for Potential Application as Water Pollution Sensors
por: Viskadourakis, Zacharias, et al.
Publicado: (2023)

Cannot write session to /tmp/vufind_sessions/sess_31l4le4v3gnar1jfjs17h5if37