Cargando…

Combustion Synthesis and Reactive Spark Plasma Sintering of Non-Equiatomic CoAl-Based High Entropy Intermetallics

The present work reports the direct production of a high-entropy (HE) intermetallic CoNi(0.3)Fe(0.3)Cr(0.15)Al material with a B2 structure from mechanically activated elemental powder mixtures. Fast and efficient combustion synthesis (CS), spark plasma sintering (SPS), and reactive SPS (RSPS) metho...

Descripción completa

Detalles Bibliográficos
Autores principales:	Kuskov, Kirill Vasilevich, Nepapushev, Andrey A., Aydinyan, Sofiya, Shaysultanov, Dmitry G., Stepanov, Nikita D., Nazaretyan, Khachik, Kharatyan, Suren, Zakharova, Elena V., Belov, Dmitry S., Moskovskikh, Dmitry O.
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC9966466/ https://www.ncbi.nlm.nih.gov/pubmed/36837121 http://dx.doi.org/10.3390/ma16041490

Ejemplares similares

SHS-Derived Powders by Reactions’ Coupling as Primary Products for Subsequent Consolidation
por: Aydinyan, Sofiya, et al.
Publicado: (2021)

Electrical and Heat Distributions and Their Influence on the Mass Transfer during the Flash Spark Plasma Sintering of a Cu/Cr Nanocomposite: Experiments and Numerical Simulation
por: Abedi, Mohammad, et al.
Publicado: (2022)

Behavior of Intermetallic Compounds of Al-Ti Composite Manufactured by Spark Plasma Sintering
por: Park, Kwangjae, et al.
Publicado: (2019)

Combustion Synthesis of Magnesium-Aluminum Oxynitride MgAlON with Tunable Composition
por: Akopdzhanyan, Tigran, et al.
Publicado: (2023)

Effect of Intermetallic Compounds on the Thermal and Mechanical Properties of Al–Cu Composite Materials Fabricated by Spark Plasma Sintering
por: Kim, Kyungju, et al.
Publicado: (2019)

CO oxidation and organic dyes degradation over graphene–Cu and graphene–CuNi catalysts obtained by solution combustion synthesis
por: Khort, Alexander, et al.
Publicado: (2020)

Two-Layer Nanocomposite TiC-Based Coatings Produced by a Combination of Pulsed Cathodic Arc Evaporation and Vacuum Electro-Spark Alloying
por: Kiryukhantsev-Korneev, Philipp, et al.
Publicado: (2020)

Hard Wear-Resistant Ti-Si-C Coatings for Cu-Cr Electrical Contacts
por: Kiryukhantsev-Korneev, Ph., et al.
Publicado: (2023)

High-Temperature Wear Performance of hBN-Added Ni-W Composites Produced from Combustion-Synthesized Powders
por: Kumar, Rahul, et al.
Publicado: (2022)

Novel Pathway for the Combustion Synthesis and Consolidation of Boron Carbide
por: Zakaryan, Marieta K., et al.
Publicado: (2022)

Investigation of Formation Behaviour of Al–Cu Intermetallic Compounds in Al–50vol%Cu Composites Prepared by Spark Plasma Sintering under High Pressure
por: Kim, Dasom, et al.
Publicado: (2021)

Microstructure and Mechanical Properties Evolution of the Al, C-Containing CoCrFeNiMn-Type High-Entropy Alloy during Cold Rolling
por: Klimova, Margarita, et al.
Publicado: (2017)

Mechanical Behavior of a Medium-Entropy Fe(65)(CoNi)(25)Cr(9.5)C(0.5) Alloy Produced by Selective Laser Melting
por: Povolyaeva, Elizaveta, et al.
Publicado: (2023)

FEM Optimisation of Spark Plasma Sintering Furnace
por: Kellari, Demetrios Vasili
Publicado: (2013)

Extremely hard and tough high entropy nitride ceramics
por: Moskovskikh, Dmitry, et al.
Publicado: (2020)

Design of non-equiatomic medium-entropy alloys
por: Zhou, Yang, et al.
Publicado: (2018)

Fabrication of Fe-Al Intermetallic Foams via Organic Compounds Assisted Sintering
por: Karczewski, Krzysztof, et al.
Publicado: (2015)

All-Materials-Inclusive Flash Spark Plasma Sintering
por: Manière, Charles, et al.
Publicado: (2017)

Simultaneous Spark Plasma Sintering of Multiple Complex Shapes
por: Manière, Charles, et al.
Publicado: (2019)

Microstructure of Spark Plasma-Sintered Silicon Nitride Ceramics
por: Lukianova, O. A., et al.
Publicado: (2017)

Amino Acids Aided Sintering for the Formation of Highly Porous FeAl Intermetallic Alloys
por: Karczewski, Krzysztof, et al.
Publicado: (2017)

On the governing fragmentation mechanism of primary intermetallics by induced cavitation
por: Priyadarshi, Abhinav, et al.
Publicado: (2020)

Effect of heat wave at the initial stage in spark plasma sintering
por: Zhang, Long, et al.
Publicado: (2016)

Flash (Ultra-Rapid) Spark-Plasma Sintering of Silicon Carbide
por: Olevsky, Eugene A., et al.
Publicado: (2016)

Fabrication of Porous Materials by Spark Plasma Sintering: A Review
por: Dudina, Dina V., et al.
Publicado: (2019)

Stability of Nanocrystalline Spark Plasma Sintered 3Y-TZP
por: Chintapalli, Ravikiran, et al.
Publicado: (2010)

Proportional Integral Derivative Control in Spark Plasma Sintering Simulations
por: Jiang, Runjian, et al.
Publicado: (2021)

Investigation of the Densification Behavior of Alumina during Spark Plasma Sintering
por: Boldin, Maksim S., et al.
Publicado: (2022)

Insights on Spark Plasma Sintering of Magnesium Composites: A Review
por: Somasundaram, M., et al.
Publicado: (2022)

Dielectric Spectroscopy of Calcium Titanate Processed by Spark Plasma Sintering
por: Ctibor, Pavel, et al.
Publicado: (2023)

Characterization of Transparent Fluorapatite Ceramics Fabricated by Spark Plasma Sintering
por: Furuse, Hiroaki, et al.
Publicado: (2022)

Hydrogen enhances strength and ductility of an equiatomic high-entropy alloy
por: Luo, Hong, et al.
Publicado: (2017)

Evaluation of Equiatomic CrMnFeCoNiCu System and Subsequent Derivation of a Non-Equiatomic MnFeCoNiCu Alloy
por: Ter-Isahakyan, Artashes, et al.
Publicado: (2023)

A Self-Propagating Foaming Process of Porous Al-Ni Intermetallics Assisted by Combustion Reactions
por: Kobashi, Makoto, et al.
Publicado: (2009)

Field-Assisted Sintering/Spark Plasma Sintering of Gadolinium-Doped Ceria with Controlled Re-Oxidation for Crack Prevention
por: Mishra, Tarini Prasad, et al.
Publicado: (2020)

Influence of Sintering Process Conditions on Microstructural and Mechanical Properties of Boron Carbide Ceramics Synthesized by Spark Plasma Sintering
por: Liu, Yingying, et al.
Publicado: (2021)

Spark plasma sintering of alumina nanopowders produced by electrical explosion of wires
por: An, Vladimir, et al.
Publicado: (2015)

On the Role of the Electrical Field in Spark Plasma Sintering of UO(2+x)
por: Tyrpekl, Vaclav, et al.
Publicado: (2017)

ZrB(2)-CNTs Nanocomposites Fabricated by Spark Plasma Sintering
por: Jin, Hua, et al.
Publicado: (2016)

Localized Overheating Phenomena and Optimization of Spark-Plasma Sintering Tooling Design
por: Giuntini, Diletta, et al.
Publicado: (2013)

Cannot write session to /tmp/vufind_sessions/sess_i87fm1fc6prdgtj4vn0dbb8fme