Mostrando 361 - 380 Resultados de 790 Para Buscar '"The Power of One"', tiempo de consulta: 0.66s Limitar resultados
  1. 361
    “…Both exhibited excellent thermoelectric performance after doping with 2,3,5,6-tetrafluoro-7,7,8,8-tetracyanoquinodimethane, where PIDTT-BBT exhibited a larger conductivity (0.181 S cm(−1)) and a higher power factor (1.861 μW m(−1) K(−2)) due to its higher carrier mobility. …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  2. 362
    “…The proprioceptive biases revealed that integration—and likely also recalibration—are shaped by the superposed contributions of multiple stimuli rather than by only the most powerful individual one.…”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  3. 363
    “…In the last decade, supercapacitors with an energy content of ∼110 W h L(−1) at a power of ∼1 kW L(−1) were developed by leveraging the open framework structure of graphene-related architectures. …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  4. 364
    “…The implemented balanced 8-way PA achieved a saturated output power (P(sat)) of 16.5 dBm, a 1-dB compressed output power (OP(1dB)) of 13.3 dBm, a power-added efficiency (PAE) of 9.9% at 90 GHz and 3-dB power bandwidth was 20.4 GHz (79.2–99.6 GHz).…”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  5. 365
    “…Our design extends operation to λ = 5.2 μm with a Johnson noise-limited noise-equivalent power of 1.1 nW/Hz(1/2), no fall-off in photoresponse up to f = 1 MHz, and a predicted 3-dB bandwidth of f(3dB) > 1 GHz. …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  6. 366
    “…Single biofilm sheet (~40 µm thick) serving as the functional component in an electronic device continuously produces power density (~1 μW/cm(2)) higher than that achieved with thicker engineered materials. …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  7. 367
    “…PMSM conditions including normal, inter-coil short circuit fault, and inter-turn short circuit fault in three motors are demonstrated with different powers of 1.0 kW, 1.5 kW and 3.0 kW, respectively. The PMSMs are operated under the same torque load condition and rotating speed. …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  8. 368
    “…It is equipped with electrical heaters which allow the simulation of the thermal loads of the magnet cryostat. A cooling power of 1.4 W at 4.5 K and 25 W at the thermal shield temperature level has been measured. …”
    Enlace del recurso
    Enlace del recurso
  9. 369
  10. 370
    por Wang, Liuqing, Zhu, Dibin
    Publicado 2019
    “…Simple yet effective mechanical interventions can be applied to the harvester to enhance its power output, i.e., to increase flow velocity and to apply external magnetic interaction. …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  11. 371
    “…We analyze four hybrid models that integrate CNNs with four powerful RNNs, i.e., LSTMs, BiLSTMs, GRUs and BiGRUs. The outcomes of our experiments on the PAMAP2 dataset indicate that our proposed hybrid models achieve an outstanding level of performance with respect to several indicative measures, e.g., F-score, accuracy, sensitivity, and specificity.…”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  12. 372
    “…Graphene obtained at 80% of laser power setting (LIG-80) had higher graphene quality and more porous structure than that obtained at the lower power levels (i.e., 50%, 70%). TEM images revealed that LIG-80 had few-layer graphene structure with fringe-like patterns. …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  13. 373
    por Cassina, L.
    Publicado 2016
    “…The CLARO chip operates in binary mode and combines low power consumption (∼1 mW/Ch), wide bandwidth (baseline restored in ⩽25ns ) and radiation hardness. …”
    Enlace del recurso
    Enlace del recurso
  14. 374
    “…PDR (100%), packet delay (0.05 s), throughput (0.99 Mbps), power consumption (1.97 mJ), network lifespan (5908 rounds), and PLR (0.5%) for 100 nodes are the performance results for quality-of-service parameters.…”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  15. 375
    “…In the presented microwave pyrolysis of plastics, activated carbon was used as a heat susceptor. The microwave power of 1 kW was employed to decompose high-density polyethylene (HDPE) and polypropylene (PP) wastes at moderate temperatures of 400–450 °C. …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  16. 376
    “…This study aims to develop a 30 kHz/12 kW silicon carbide (SiC)/Si integrated hybrid power module (iHPM) for variable frequency drive applications, particularly industrial servo motor control, and, additionally, to theoretically and experimentally assess its dynamic characteristics and efficiency during operation. …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  17. 377
    por Yılmaz, Aslıhan, Tugrul, Nurcan
    Publicado 2023
    “…Corn starch was irritated using different combination of ultrasound-microwave and microwave-ultrasound treatment; using 90, 180, 360 and 600 W microwave power during 1, 2, 3 min, and using ultrasound at 35 °C constant temperature for 20, 30, 40 min. …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  18. 378
    “…A maximum on-off peak gain of 30.4 dB was obtained using 10 W of peak pump power at 1.99 μm, with simulations indicating that the gain could be increased to up to ~50 dB by extending the SCF length. …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  19. 379
    “…Sleep, measured with polysomnography, was analyzed to assess changes in sleep architecture and spectral power. After 1 h of flashes, DLMO showed a substantial delay (1.13 ± 1.27 h) compared to placebo (12 ± 20 min). …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
  20. 380
    “…The extract had high antioxidant properties, as indicated by the IC(50) values obtained for 2,2-diphenyl-1-picrylhydrazyl (DPPH) (366.33 μg/mL) and 2,2′-azino-bis (3-ethylbenzothiazoline-6-sulfonic acid (ABTS) (169.04 μg/mL), as well as the ferric ions reducing antioxidant power (FRAP) (1.67 μg ascorbic acid equivalent/g of the extract). …”
    Enlace del recurso
    Enlace del recurso
    Enlace del recurso
    Online Artículo Texto
Herramientas de búsqueda: RSS