“…MATERIALS AND METHODS: Five implants (4 mm diameter and 10 mm length) were placed into the resin-based mandibular model and 1-piece of screw-retained metal substructure was produced with the direct metal laser sintering (DMSL) method using Co-Cr compound (n = 10). …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…Eukaryotic chromosomes are replicated in interphase and the two newly duplicated sister chromatids are held together by the cohesin complex and several cohesin auxiliary factors. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…Zn-doped calcium copper titanate (CCTO) was successfully synthesized by rapid laser sintering of sol-gel derived precursors without the conventional long-time heat treatment. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…This study is an example of using 5-ethynyl-2′-deoxyuridine (EdU) for detecting sister chromatid exchanges (SCEs) at chromosomal level. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…The 7075 aluminium alloys was completely densified under the 500 °C sintering temperature and 60 MPa pressure. The large powders constituted coarse grain zone, and the small powders constituted fine grain zone in sintered 7075 aluminium alloys. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

Enlace del recurso
Enlace del recurso
Enlace del recurso

“…This study uses population genomic data to estimate demographic and selection parameters in two sister lineages of the wild yeast Saccharomyces paradoxus and compare their evolution. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…A low cost Ti–Si intermetallic compound membrane with nano-pores was successfully prepared by an in-situ reactive sintering process. The all synthesized membrane shows the presence of Ti, Ti(5)Si(3), TiSi and TiO(2) phases, and the Ti:Si atomic ratio of membrane is about 1.9. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…In situ utilization of available resources in space is necessary for future space habitation. However, direct sintering of the lunar regolith on the Moon as structural and functional components is considered to be challenging due to the sintering conditions. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

Enlace del recurso
Enlace del recurso
Enlace del recurso

“…The purpose of the conducted experiments was to test the selected properties of materials intended for porous sintered bearings containing layered materials in the form of powders with an average particle size of 0.5–1.5 μm, with very good tribological properties. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…Selective laser sintering (SLS) is being developed for dental applications. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…Titanium carbide (TiC) reinforced nickel (Ni) matrix composites were processed via mechanical alloying (MA) followed by spark plasma sintering (SPS) process. Mechanical alloying has gained special attention as a powerful non-equilibrium process for fabricating amorphous and nanocrystalline materials, whereas spark plasma sintering (SPS) is a unique technique for processing dense and near net shape bulk alloys with homogenous microstructure. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…In this study, the authors attempted to propose the very first study on fabrication and characterization of zinc-boro-silicate (ZBS) glass-ceramics derived from the ternary zinc-boro-silicate (ZnO)(0.65)(B(2)O(3))(0.15)(RHA)(0.2) glass system through a conventional melt-quenching method by incorporating rice husk ash (RHA) as the silica (SiO(2)) source, followed by a sintering process. Optimization of sintering condition has densified the sintered samples while embedded beta willemite (β-Zn(2)SiO(4)) and alpha willemite (α-Zn(2)SiO(4)) were proven in X-ray diffraction (XRD) analysis. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…Raw PT (RPT) is toxic and must be processed before clinical use. Licorice-simmered PT (LPT) is one of the most common processed products. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…According to international guidelines, treatment of HH is indicated when serum ferritin concentrations are above the upper limit of normal. We report two sisters who presented to the rheumatology clinic with arthralgia, which was subsequently found to have a homozygous mutation variant of unknown significance in the HFE2 gene: c.497A>G;p.…”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…This paper focuses on reporting results obtained by the spark plasma sintering (SPS) consolidation and characterization of aluminum-based nanocomposites reinforced with concentrations of 0.5 wt%, 1 wt% and 2 wt% of single-walled carbon nanotubes (SWCNTs) and multi-walled carbon nanotubes (MWCNTs). …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…This work aims to assess the suitability of a CO(2) laser (λ = 10.6 μm) for selective laser sintering of SODFs containing copovidone and paracetamol. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…Carbon nanotubes (CNTs) consolidated by spark plasma sintering (SPS) were inactive in the conversion of secondary C(3)-C(4) aliphatic alcohols because of the «healing» of defects in carbon structure during SPS. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso

“…The samples were sintered at 900 °C, 1000 °C, 1100 °C, and 1200 °C to elucidate the influence of sintering on the physical and microstructural properties. …”
Enlace del recurso
Enlace del recurso
Enlace del recurso