Modular Architecture of a Non-Contact Pinch Actuation Micropump

This paper demonstrates a modular architecture of a non-contact actuation micropump setup. Rapid hot embossing prototyping was employed in micropump fabrication by using printed circuit board (PCB) as a mold material in polymer casting. Actuator-membrane gap separation was studied, with experimental...

Descripción completa

Detalles Bibliográficos
Autores principales: Chee, Pei Song, Arsat, Rashidah, Adam, Tijjani, Hashim, Uda, Rahim, Ruzairi Abdul, Leow, Pei Ling
Formato: Online Artículo Texto
Lenguaje:English
Publicado: Molecular Diversity Preservation International (MDPI) 2012
Materias:
Article
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC3478859/
http://dx.doi.org/10.3390/s120912572

Internet

https://www.ncbi.nlm.nih.gov/pmc/articles/PMC3478859/
http://dx.doi.org/10.3390/s120912572

Ejemplares similares