EDM of Ti-6Al-4V under Nano-Graphene Mixed Dielectric: A Detailed Investigation on Axial and Radial Dimensional Overcuts

Ti-6Al-4V is considered a challenging material in terms of accurate machining. Therefore, electric discharge machining (EDM) is commonly engaged, but its low cutting rate depreciates its use. This issue is resolved if graphene nanoparticles are mixed in the dielectric. However, the control over the...

Descripción completa

Detalles Bibliográficos
Autores principales: Ishfaq, Kashif, Asad, Muhammad, Harris, Muhammad, Alfaify, Abdullah, Anwar, Saqib, Lamberti, Luciano, Scutaru, Maria Luminita
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2022
Materias:
Article
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8837981/
https://www.ncbi.nlm.nih.gov/pubmed/35159777
http://dx.doi.org/10.3390/nano12030432

Internet

https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8837981/
https://www.ncbi.nlm.nih.gov/pubmed/35159777
http://dx.doi.org/10.3390/nano12030432

Ejemplares similares