Wafer scale manufacturing of high precision micro-optical components through X-ray lithography yielding 1800 Gray Levels in a fingertip sized chip

We present a novel x-ray lithography based micromanufacturing methodology that offers scalable manufacturing of high precision optical components. It is accomplished through simultaneous usage of multiple stencil masks made moveable with respect to one another through custom made micromotion stages. The range of spectral flux reaching the sample surface at the LiMiNT micro/nanomanufacturing facility of Singapore Synchrotron Light Source (SSLS) is about 2 keV to 10 keV, offering substantial photon energy to carry out deep x-ray lithography. In this energy range, x-rays penetrate through resist materials with only little scattering. The highly collimated rectangular beam architecture of the x-ray source enables a full 4″ wafer scale fabrication. Precise control of dose deposited offers determined chain scission in the polymer to required depth enabling 1800 discrete gray levels in a chip of area 20 mm(2) and with more than 2000 within our reach. Due to its parallel processing capability, our methodology serves as a promising candidate to fabricate micro/nano components of optical quality on a large scale to cater for industrial requirements. Usage of these fine components in analytical devices such as spectrometers and multispectral imagers transforms their architecture and shrinks their size to pocket dimension. It also reduces their complexity and increases affordability while also expanding their application areas. Consequently, equipment based on these devices is made available and affordable for consumers and businesses expanding the horizon of analytical applications. Mass manufacturing is especially vital when these devices are to be sold in large quantities especially as components for original equipment manufacturers (OEM), which has also been demonstrated through our work. Furthermore, we also substantially improve the quality of the micro-components fabricated, 3D architecture generated, throughput, capability and availability for industrial application. Manufacturing 1800 Gray levels or more through other competing techniques is either limited due to multiple process steps involved or due to unacceptably long time required owing to their pencil beam architecture. Our manufacturing technique presented here overcomes both these shortcomings in terms of the maximum number of gray levels that can be generated, and the time required to generate the same.